I have a slight misfire coming from a coil on my passengers head. I checked them all out and one has some rust on the actual coil/spring itself. Is there any way to clean it until my new ignition set comes Tuesday? There's no CEL and all the spark plugs are brand new.
I'm looking at a kit from rearseatdelete.com
and had a couple questions. Is the small amount of weight savings worth it and are they strong enough for passengers?
I recently had the CEL come on for low voltage on the TPS. I just replaced it with a TPS Sensor from AutoZone and it idles at 4000RPM! I unplugged it and the idle dropped to 1200 but then shot back up to 4000rpm. I checked and there's no vacuum leaks or codes being thrown. What could be the...
I've been having a problem with my cigarette lighter lately. I can use it to charge devices like my phone with no problems. However, when I plug in my radar something weird happens. Every time I accelerate moderately to really fast it has a LASER alert and there is definately a correlation with...
I know this is one of the most talked about subjects on the board but there's a few reasons why I haven't changed my 3.27s. I like being able to go 160 in fourth, I like the way my car pulls from 100 on, and 5th gear is overdrive so being in fifth at high speeds puts a huge load on the engine...
I got bored and decided to paint and vent my coil covers. I marked off the holes and then used a drill press. Then I used scotchbrite and sandpaper before applying some high temp paint. I'm making a catch can tonight.
EDIT: & Its my 400th post!
I've raced these guys before and have beat them. This one had intake/exhaust/interior panels and backseats removed. He pulled lengths on me with no problem from a 40 & 60 roll. Does this sound right?
My A/F is @12 WOT (I know... I know:nonono:). My TPS voltage was at .8 at idle, and my idle is...
My rear wheels seems to be tilted inwards a little bit. (toe in) It drives fine but the tire wear is slightly more prominent then it used to be. I recently had the entire suspension redone (bushings) and noticed the spindle bearing is broke. Could it just need to be aligned or is it something...
I had a vacuum leak, that I recently fixed and it's been idling really high 1k-1500rpm. The air/fuel is fine and the car drives fine. I tried resetting the ecu by disconnecting the battery and pressing the brakes to drain any excess electricity and when I turned the car back on it started to...
Also referred to as a lower chassis brace or K-member brace. It's new with hardware, but I can't find the installation instructions. Maximum Motorsports has an install guide for a very similiar brace on their site. If I find the instructions I will include them. It said 96-04 but I couldn't get...