Recent content by hus

Steeda Firewall Adjuster and Quadrant. Both have about 40 miles of use. Had a whole new motor installed and while ordering parts a whole other Steeda Adjuster, Firewall and Cable kit got order and installed so I have this used one up for sale. Both together = $45 shipped! PM or email...

Ok so I bought the Spec Stage 2+ and after about 10 miles of use decided to swap it for the Spec Stage 2 (no plus). You'll see from the pictures that it doesn't have any use. This same setup would cost you about $380 shipped new, yours (pressure plate, clutch disc and bearing) for $300...

Well, I finally got the miles on the car and got it up to Dynospeed Racing for the dyno tune and numbers. There's good news and then there's "not so good" news. Good news is the car made 463rwhp and 404rwtq. That's up from the previous of 436rwhp and 390rwtq. The "not so good" news...I'm...

Ok, since the other thread spanded about 4 months I decided to start this new one for fresh clean start. I'll explain the build, the parts and the price as I go along. I can post pics but to be honest, there is absolutely nothing that looks any different than before other than the top part of...

My MMR 4.6 Street Mod 800 Shortblock arrived at DYNOSPEED Racing the other day and DYNOSPEED came and picked up my car to do the install. I basically spun a bearing on my stock block and so I ordered the MMR with a 9.5:1 CR to go with my Vortech and Paxton Intercooler. I'll try to get some...

Couldn't find where this had ever been posted on here and I found it searching through my saved vids: YouTube - {UNBELIEVEBLE} RX-7 CRASHES AT 215 mph

YouTube - 2010 ROUSH 427R Mustang

I just got finished reading the June 09 Muscle Mustangs and Fast Fords Mag for like the 5th time and I was reading up on the "Heritage & Horsepower" article featuring the Gulf Blue/Coral Orange GT500 and was wondering if there are any 99-04 Cobras out there painted the scheme or if any body can...

:bash: Ok so I bought my 01 Cobra in 2007. The very day I bought it the non-intercooled Vortech V-2 and my foot melted the number 6 piston. That was mistake number 1. :bash: Mistake 2. The bigger mistake however was getting a "friend of the family" mechanic that has worked on all my...

So I'm looking into building up a shortblock as a project for my 01 Cobra because I keep running into problems ever since I had my stock block rebuilt. I will be throwing my Vortech and Intercooler on the new block whichever it is. Any experiences with either block mentioned below would be...

:rolleyes: My Cobra is down due to a series of Spec clutch install issues (see my thread: http://www.svtperformance.com/forums/new-edge-cobras-51/591989-need-clutch-install-help-not-releasing-spec-stage-2-a.html ). So I was still wanting to go to Barber's in B'ham for the 45th Anniversary...

My mechanic says he cannot get the clutch to release after installing it. He says its taking him both feet to push the clutch pedal down and then it will not release. Is there something he's missing here? He's installed the Spec Stage 2+ Clutch Kit, Spec Billet Steel Flywheel, throwout...

Just a few pics:

Well, I figured it would happen. When I had my engine forged my mechanic replaced my clutch with one from Ford Racing and I had my Paxton Intercooler and a 2.87 pulley added to my Vortech and then had a new tune. Well my car went from 378rwhp to 436rwhp and from 345rwtq to 390rwtq, and after...