egr

So I purchased all my parts and they're on the way, it'll be a busy couple of days to get it all done, but she'll be pristine by the time i'm done. I figured I'd try out AM's Bama iTSX Wireless Tuner: Bama Mustang iTSX Wireless Tuner w/ 3 Custom Tunes 38029G94SE (96-98 Cobra) ...and see how it...

I have an 08 gt500. Headers were installed prior to my ownership. EGR was welded shut on both valve and passenger side header. I replaced the valve, and drilled out the header roughly a month ago. No codes for p 0401 until today. My tuner will not adjust this parameter in the tune. Is everyone...

I am in the middle of my blower swap and have deleted EGR. I realized there are a few plastic vacuum lines (red and green in color) and wanted to know if I can just leave them there or if I need to block them off somehow. In addition to that, I was not wise and did not pay attention when I...

Currently in the process of installing my VMP Gen 2R and the EGR tube is being an absolute pain. So I'm just about to order a EGR delete kit and be done with it. My only concern is getting the vacuum lines right for the SIP. I looked at a guide (I believe was posted on here but was for a...

I'm getting ready to install a VMP Gen II blower this spring and I need to keep the EGR and the associated "birds nest" on the driver's side of the blower due to emissions requirements. The VMP does not have a bracket to attach the whole mess to the blower like on the stock Eaton. I've seen...

Alright guys so i have a 2003 cobra, I went to delete my EGR from my car (the bracket on the side of the supercharger with the associated modules). Now when the car is under slight boost or any boost at low rpms the car will stutter almost like a misfire for a quick second. I have replaced the...

I've had the good old P0171 Bank 1 Lean code for a couple of years now. I've tried replacing the vacuum line that goes to the back of the s/c, pcv, o2 sensor, fuel filter,tested for intake leaks, and cleaned the intake/tb all with no luck. I would assume if it was a cat I would be getting...

I had done a Romeo 2v swap on my '00 Mustang GT and swapped over my intake, TB, Plenum, etc. But then I got the following symptoms of:Rough idle, Low idle RPM (In my opinion), smells like gas when I turn it on, and bucks when I let off the brake. A check engine light did come on. Which was P0402...

Howdy folks. . I have looked at most of the posts in the forums on doing the delete or modifying the system. None of the posts I have seen deal with the KB, just the Eaton. I don't know if there is a plumbing difference between Eaton and KB EGR Vacuum systems. Any thoughts? I'm learning as I...

Just wanted to share my experience with everyone regarding my EGR getting stuck in the closed position. From what i was able to read online, an EGR stuck closed will cause the cylinders to heat up due to not having the cooling EGR gasses, causing the car to dump fuel into the cylinder to get...

I need a new EGR valve for my 1993 ford lightning but i cant find one that fits. All the ones online that they say will fit the 5.8l engine wont fit. The number on the EGR valve that i took off is f-3te-9f483-h2a. I can find this part anywhere, i even called up Ford and they said they dont have...

Turbo intake setup. It uses a sheet metal intake that sits in the place of the blower and the factory upper plenum. It comes with a JDM phenolic spacer, and the upper plenum is set up for EGR delete. $175 shipped to your door including paypal fees.