When you guys assemble your engines from shortblock form, do you install oil pan or front cover first?
I am trying to figure out how to best apply the RTV to the oilpan gasket that meets the front cover. Should I install oilpan and RTV just the rear section and then RTV the rest when I...
Paxton 2200SL Tuner Kit
+JLT Intake
+ID 1000 Injectors
+SCT X3 Tuner
Comes with modified coolant hoses that I want to trade for stock ones and modified PCV hoses as well that I want to trade for stock ones.
$4200 For everything. Located in Dallas
Local pickup only or you pay for shipping and...
So I installed the JPC breather kit on my car. I wanted to limit how much oil gets in the intake.
During the week i only did 1-4th gear pulls and had no issues. Little bit of oil on the driver filter.
Today I hit an empty stretch of freeway and did a 5th gear pull to about 155mph. Started...
Just got my car retuned for e85 at True Street Motorsports.
Only Mods
Paxton 2200 from Beefcake Stock pulley
ID1000's
KB BAP
JLT Intake
E85 Tune :)
Must be worlds cheapest 700whp build. Still running stock exhaust with cats.
Alluminator for christmas, since i know it won't last.
When it's cold in the morning twice now, I have gotten P050E Code.
2013 GT with Paxton 2200SL ID1000's, JLT Intake.
Stock exhaust.
Any ideas what could cause it?
The code description is Cold Start Engine Exhaust Temperature Too Low.
Just got back from a event in bakersfield, airstrip roll racing. Head to head 40mph half mile runs. Was hitting about 165mph at the half mile mark.
Ran about 15 times. Won a few, lost a few as well. Car was running 91 octane + torco, about 600whp, maybe a tad less. Stock pulley, stock...
I have a set of brembo wheels for sale $450
Local pickup only.
No tires no tmps.
They have 5K miles on them. One front has very small rash. Other 3 are perfect.
I am looking to trade my 4400 mile 2013 diff 3.73 ratio for a low mileage 3.31 diff.
I can help swap them out in my garage. Basically replace entire diff assembly, so I don't have to pay someone to dial in the gears.
I need the 3.31 for more traction with my paxton supercharger.
I am...
Anyone run into an issue where the cruise control stopped working? I have 3500 miles on my 2013 car, i rarely use cruise but i was driving to vegas today and tried to turn it on and nothing happens. When I turn the cruise button on, I don't get the light on the dash. I tried setting a speed and...
I had my car tuned with a Paxton Kit GT500 Injectors and Kenne Bell BAP on my 2013 GT 6 speed.
The BAP is wired to be 100% on at all times.
After the tune driveability when cold is less than perfect, a bit of surging and idle issues. When it warms up it drives normal.
Problem is gas...
Just had my 2013 Mustang tuned by Greg at RET.
Made 569/434 Dynosheet at the end of the video.
Following Mods.
Paxton 2200SL Tuner Kit from Beefcake
GT500 Injectors
Kenne Bell Bap
JLT Intake
Everything else stock. Car has 2000 miles on it.
Tuned on 91 octane.
Tibor 2013...
Finally my new toy arrived.
Paxton 2200SL Kit from Beef.
Will be installing it on Saturday.
It will go on my 100% stock 2013 GT.
I also got the Kenne Bell BAP and JLT Intake.
Getting it tuned by Greg at RET next week, hoping for 580whp.
Got a base dyno done on my car before I install the paxton supercharger.
2013 GT 6MT, 3:73 gears, dynoed in 5th gear. 1000miles on it. 100% Stock 91 octane. 91 degree heat.