Recent content by Storm728

SCT x3/sf3 150$ shipped Used once need an x4 for my new car. Unmarried and 4 unlocks left. 150 shipped. Text me at 9495549216

Both on car for less than 1000 miles Tb 350 shipped Bbk shorty Headers ceramic coated 350 shipped. Comes with new gaskets 650 if you buy both Text me at 9495549216

Used once need an x4 for my new car. Unmarried and 4 unlocks left. 220 shipped. Text me at 9495549216

FS Bassani O/R X pipe Manley souvenier rod etc Bassani o/r x pipe 99-04 180$ will not ship Manley svt souvenier connecting rod. 40$ shipped Stock 03/04 cobra intake tube. 20$ shipped Ford Racing stainless fuel door 40$ shipped 03/04 cobra aluminum flywheel 50$ shipped 90mm cone filter...

Ive got this new creaking noise whenever i pull into my parking garage. i can only hear it when going at an angle up or down the entry ramp. no idea what it could be so any thoughts would be appreciated. suspension mods include urethane diff mounts, subframe mounts. hr race springs with only...

got a bunch of stuff laying around need some extra cash for a motor build. Bassani o/r x pipe used 200 will not ship oem cobra aluminum flywheel 10k miles used 70 oem cobra coupe springs used 100 03/04 stock intake tube 30 sct ba2300 with filter adapter 180 c&l intake cone and shield 40...

planning a rebuild soon. almost certain motor will need new pistons. considering j/e, cp, wiesco, manley, mahle, diamond or those crazy red pistons mmr sells. planning on staying stock compression (for this reason i am also considering stock pistons). car will probably be pullied and boltons...

makes the noise only when the car is warmed up. had it as long as i can remember. pre november engine build 2002.https://www.facebook.com/photo.php?v=638646942838652&l=2635694520817038005 sorry for the upload location, i couldnt upload it anywhere else due to the size

I'm itching to put this 2.8 pulley I have laying around on my car and getting a retune but I'm very paranoid from all the horror stories people share about head ticks burned pistons etc. I would spring straight to a twin screw if I had that kind of spare cash laying about but unfortunately I...

Putting in a reische 170 tstat. However my car already has a tune in it which was done when the car was very young. I have an unmarried xf3 from my old mach and I was curious if I could alter the fan settings solely with the programmer without messing up the tune that the car already has.

just need a reference point for what a correctly toe aligned cobra rear wheel looks like so i can get it close before i drive to alignment. thanks

planning on adding a 2.8 pulley soon. my motor is a pre november head revision build so im a bit concered about the whole tick issue. i have a lfp head cooling mod, 170 reisch tstat ready to go on and was also planning on an afco dual pass h/e. i dont really hit 5th when going wot but better...

picked up the full mm toe link kit and the instructions provide a base point for the inner spacer settings but no indication whatsoever for the outer end. i know measured bumpsteer adjustment must be done to get it right but im wondering if anyone has any experience with a baseline to start at...

need to get this asap pm me

just picked up a new cover. noticed the spot for the temp sender and thought i might as well tap it and put in a sensor while i have the irs out even if i dont use it immediately. however i cant seem to find a sensor that is surefire intended for this. any suggestions?