It's time to part ways. I bought the car new in 2004 with 8 miles on it.
2003 10th anniversary cobra
Silver with 11100 miles on it
Billet flow pullies, ported stock supercharger
Full length sub frames
Ceramic longtube headers
Prochamber H pipe, flow master exhaust
Acufab throttle body
K&n...
I had headers installed a few weeks ago. Then I started getting this vibration in the gas pedal at 2700rpm. I pulled the pass wheel off and the black plastic piece in the wheel well, and tightened all of the bolts I could get at. The vibration went away. Then it came back after a few weeks...
I installed MAC longtubes the other day. It was a pain in the butt I had to drop the K member. Now I get sometype of vibration in the gas pedel at certian RPMS. They only thing I can think of that would cause this is some of the header bolts getting loose after they got hot while driving. Any...
Who is going from the western part of the state, and does anyboby want to meet up and drive down. White98cobra and I will be leaving the Springfield area around 9am.
I will be installing the H&R sport springs tonight with the spring isolators. I can figure out where the donut looking part of the spring isolator goes, but I don't know where the red tube like peice goes. Does it slide up the spring to absorb road vibrations? Any insight on where the tube peice...
I decided to go with the Apten port job after they offered there special September pricing. First thing I did was go to the dyno to get a base line number. 441.6RWHP and 458RWTQ with mods in sig. Absolute barometric pressure29.92hg, intake air temp 88.0F with a correction factor of 1.00, time...
I took my blower off to send to Apten for the September special. Taking the blower off was not hard. Everyone talks about breaking the intercooler bolts off. The tool I used was a 18v Snapon impact gun, I didn't even snap one bolt. I hope this will help someone in here when they take their...