Recent content by grey03mach1

I am selling my car so I will not be needing these wheels. I just purchased them from Jegs like 3 weeks ago. They are 15x10 with 6.5 bs and 4.5 bolt pattern. I will also include matching lug nuts. The tires are MT ET Drags 26x15x10 with around half or their rubber left. The wheels were...

I hate to do it but I need something more practical. It is Oxford White with the parchment interior. Mods are OR/x-pipe,Flowmasters,K&N CAI,Pulley and RWTD tune. It dyno'd 480hp/473tq at Stanghi. Thats 466hp 458tq corrected. I am going to take some pictures of the interior and some engine...

I have a friend that has a viper with run flats. We was wondering if lowering the pressure would help it hook better. I do not have any experience with RF's so I do not know.

I was looking at buying a set of rims for the back of my Cobra. I ran across some 15x10 with a 7 1/2 backspacing. Will they fit or is that too much?

Yeah I have a friend that owns a 2008 Shelby. He just upgraded to bigger injectors and wants to sell his stock ones which are 59 lb I think. Will they fit my plug-ins? If I have to do much modifying for it to work I think I'll just pass. Has anybody used stock injectors from a Shelby?

My car is a 2003 Cobra with a 2.93 pulley, CAI, O/R x pipe, Flows. No tune but I did have it dyno'd and A/F checked. Supposed to get mail order tune this week. Car put down 480 hp 473 tq corrected (466hp 458 tq). Best pass was 12.6 @ 113 mph w/2.0 60ft. I ran a couple of 12.7 and 12.8's...

OK, I bought an Oxford White Cobra about a month ago with 50k miles on the clock. The only visible modifications that I can see are a CAI, Flowmasters and a smaller pulley. The belt was slipping when I got it and it was a 74.5 inch belt. I replaced it with a 74 inch belt (the 73.5 belt was...

I've only had my Cobra for a couple of months so I'm still figuring out a few things. Whenever I am running the car to redline and if I do not power shift there is a very noticeable hesitation at start of new gear. It feels like it is completely stalling then it picks up again and runs strong...

I was driving the car normally in town and I looked down and noticed the temp gauge almost pegged. I was able to make it home before damaging anything. I think it may be my heater coil. I have been smelling antifreeze in the car but no leaks on the carpet. I changed the thermostat and...

It was several years ago but I'm sure it can be found. It was of a street race between a C5 coupe and a Cobra. The Cobra dusted the Vette and the vette owner was baffled. He is heard asking "What is that sound? Is that a Sc'er?

I have made an appointment with Stang-Hi but I am not liking the way they pressure u to buy, buy buy. I called to arrange a dyno pull to see where my numbers are and to check my A/F. Salesman calls me back to persuade me to buy a SCT tuner 380.00, Custom tune 400.00 and a consult 125.00...

A Missouri Sheriff stops at a ranch in rural MO > and talks with an old farmer. > > He tells the farmer, 'I need to inspect > your ranch for illegal grown drugs.' > > The old farmer says, 'Okay, but don't go in that field over?there.' > ? > The Sheriff...

I just aquired an 03 Cobra with 50k miles last friday. It has a smaller pulley on the SC'er but do not know the size. My belt also has a small cut on the outside. It will sometimes slip under WOT and squeal a little. It also has a little to much slack. I am going to buy another belt and may...

I just purchased an 03 OW Cobra with 50k miles. I have never driven one before so I do not know first hand how the transmission or clutch is supposed to feel. However, my clutch pedal is a real workout in stop and go traffic. This is ridiculous if this is the norm. Also the trans. is notchy...

How much for a good paint job nowadays? Guestimation?