someone should try a 3.1 upper and stock lower so i dont have to be the first one.
someone should try a 3.1 upper and stock lower so i dont have to be the first one.
So if it is internal gearing, what would happen if one tries to install a 2.76 w/4lb lower?
Would it last or would the heat be too great.
I don't think anyone has tried (Or, documented at least) extreme pulley combos like that. A 2.65 upper/6# lower would spin around 22,000 RPMs, which really isn't that far out of range of what people are spinning Eaton's at now. I'd be interested to see what, say, a 2.65/4# combo would do on top of the SnakeBite.
I don't think anyone has tried (Or, documented at least) extreme pulley combos like that. A 2.65 upper/6# lower would spin around 22,000 RPMs, which really isn't that far out of range of what people are spinning Eaton's at now. I'd be interested to see what, say, a 2.65/4# combo would do on top of the SnakeBite.
So basically if you have a ported blower making 17psi, and you get the smake bit and run 17psi, you will be making the same power?
I'm thinking anything over 17-18psi out of the Eaton would be creating to much heat.
I like to run stock parts and go fast, thanks
I wonder how much power I could pick up with long tube headers? any ideas?
just for reference we just put a stage 5 on a cobra with LTs, accufab tb/pl, 2.70 upper that made 15.5#s of boost @ 20 degrees of timing and it did 535rwhp 510rwtq STD which shows higher than SAE numbers. this snake bite did this with no headers and in SAE numbers guys.
On my snake bite one rotation of the pulley made 1 1/3ish rotations of the rotors by the looks of it for people asking about the drive gearing, i believe stock is one to one and these are definitely the stock rotors
OP found an idler that with work on my aux bracket so my belt size will be different thx though
So if it is internal gearing, what would happen if one tries to install a 2.76 w/4lb lower?
Would it last or would the heat be too great.
So basically if you have a ported blower making 17psi, and you get the smake bit and run 17psi, you will be making the same power?
I'm thinking anything over 17-18psi out of the Eaton would be creating to much heat.
So basically if you have a ported blower making 17psi, and you get the smake bit and run 17psi, you will be making the same power?
Well I just posted up My #'s for you guys, I did not know this thread would turn in to drama like this.
Like I said before I do not care about dyno #'s, when the weather gets better I will give some drag stips results so guy's can nit pick that apart. LOL
Thanks for postive reply's svtp.
If anyone else has some drama to spread please make your own thread, I'm just giving some info . not looking for a E-War
Well I just posted up My #'s for you guys, I did not know this thread would turn in to drama like this.
Like I said before I do not care about dyno #'s, when the weather gets better I will give some drag stips results so guy's can nit pick that apart. LOL
Thanks for postive reply's svtp.
If anyone else has some drama to spread please make your own thread, I'm just giving some info . not looking for a E-War