tob

I got a seat swap question not addressed elsewhere. I know at least one other member (sweetlou1182) is having the same problem. I have a ‘13 GT. I picked up a set of Recaros out of a ‘14 GT but when I install them it triggers the dash & dome airbag lights. When I bolt in my stock passenger...

Hey guys, I have an 11 Gt500 and Im getting some grinding noise from my transmission while letting the clutch out. It is faint while in neutral and letting it out. With the clutch in I can move the tranny into any gear without issue. When I am in any gear and start to let the clutch out i get a...

I am in the process of installing my Mantic clutch and am struggling with understanding where the tob should be in relation to the fingers on the pressure plate with the cable off. With my cable off I have a ton of space between the tob and the pressure plate. Does this mean I need to pull it...

Months ago I had my throwout bearing and clutch replaced (exedy stage 3), i ended up needing a flywheel too. after my mechanic got it all in, the car wouldn't go into gear, so i went and bought a new adjustable clutch cable, tightened the shit out of it and it went into gear. on my way home on...

I bought this vehicle just over 8 months ago with 20k miles. I got it from a guy up in Little Rock. He was the 4th owner & said it has a Spec Stage 3+ clutch & that he had replaced the TOB when he purchased it around 18k miles. When I picked it up I drove it 600 miles straight from Little Rock...

I need to replace the throwout bearing on my 96 Cobra, and while I'm at it I'll replace the pilot bearing and clutch, as well as rear main seal and transmission rear seal. I also plan to install a MM clutch cable kit with firewall adjuster and quadrant. I've already ordered a Ford Racing pilot...

My clutch crapped out Friday, it's a toy with 800 hp on e 85... Car ran fine no issues... Clutch was over powered rated at 550 hp so I know it's a matter of time.... I'm looking to do a 26 spine swap... So what is needed or recommend while it's out? I have read I can resurface the...

Hello all! Need some help in diagnosing the damage done from my tob failing. I have pulled the trans and attached pictures. As you can see the tob apart and was in pieces with dust everywhere and balls for the bearings just falling out as I pulled the trans off bellhousing. What damages may have...

MHUhlpirMoU https://www.youtube.com/watch?v=MHUhlpirMoU

TOB is starting to sqeal......i see this as a common problem on the 03-04 cobras...mines an 04 with about 63xxx miles on it so, looks like its that time. im thinking FRPP TOB but not sure what clutch i want, previous owner bought a stedda adj clutch quad, dont know if it was installed. also, i...