Recent content by MVD

SOLD Thank you.

I sent a PM to Ken (Hissssnsvt) but seems he is not online much , so I figure one of you guys could answer this anyway. Ken has posted pictures of the straight shot intake he was using on the 3.4 Whipple that consisted of an underhood 12" filter and JLT 110mm MAF meter. That is the basis of...

All parts are off my 2003 Cobra and in perfect condition. Under 4,500 miles on everything. OEM stainless H pipe - SOLD OEM heat exchanger - SOLD OEM 90mm MAF meter - SOLD OEM 10 spline input shaft - $60 OEM pulley cover - $25 OEM c/c plates - $50 OEM rear brake pads - $40 Brand new...

Anyone running a 2.93/6# combo with a 3.5" alternator pulley and all 4 idlers (three 100mm and one 92mm), with OEM tensioner. What length belt are you using. I searched and came up empty. I appreciate the help.

MAC part number PC9900. Durablack coated. Used for less than 1,500 miles and in perfect condition, no scrapes or scratches. The sound is amazing, I like it so much I bought another Prochamber to go with my longtubes :thumbsup: I have several pictures too, shoot me a PM with your email...

Do you need to extend both driver and passenger side O2 harness (i.e. require two extensions)?? Thanks.

Looking at different roll bars. A 6 point chromoly roll bar from Wolfe Race Craft weighs about 60-65 pounds (according to their website). A 6 point mild steel roll bar from Maximum Motorsports weighs about 70-75 pounds (according to their tech guy). Can anyone confirm these weights?? I...

It's black, comes with all hardware and directions. $125 shipped to your door. Doesn't even look like it was installed......it is in 100% perfect condition. I accept Paypal.

I have a complete IRS assembly out of my 2003 Cobra. I am looking to sell everything as a complete unit including, IR axle, shocks, springs, isolators, chassis brackets, rotors, ABS sensors, and all hardware to mount it up. The only thing I will not be including is the calipers. I can email...

I am trying to determine what size and backspacing I need to run for a 15" drag wheel. I would like to run Prostars and not grind the caliper. Will I be safe with a 15x8 (4.5" bs) or a 15x10 (6" bs). I have searched until blue in the face but only seem to find threads about IRS setups with...

Seems like all the directions I have come across include the installation of a BAP along with the wiring upgrade. Has anyone done just the wire upgrade without a BAP? I can't seem to find any links for directions here :(

Through a majority of my searches people are have used 2 prong switches (non lighted) for the main fan and IC pump and have no problems. Of the handful who used lighted switches they did not say where they picked up their 12v source from. I picked up a 12v source off the PCM but am having...

At first I planned on getting Bassani midlength headers but realized I could only use their X pipe. What headers are people running with their ORH? I would like to run either longtubes or midlengths. Also what brand H pipe is recommended. Thanks.

http://www.svtperformance.com/forums/showthread.php?t=327933

I have been searching a lot lately and I am stuck. Basically what I want to do is run a set of skinnies at the track but still be able to run stock wheels on the street. A 15" wheel will not clear the front claiper so a wheel spacer is needed (seems like at least a 1" spacer will work)...