Recent content by Lethalvenom2008

I deleted my egr and my motor is reving up to 2,500 and down,back and forth ,its throwing a code that my maf is bad.if not having a egr cause this symptom?

it goes underneath the dash where the clutch pedal is at.i just need the connector.

Im trying to fire up my coupe and it just clicks once. the theft light is activated. I got a tune but im sure thats not the problem.i dont want to take it to ford.can i purchase a pats programmer so i can link up the key to the pats or should i just take it to ford? are their any device that...

looking for the center bezel where it covers the shifter .it has clips to snap into the center consol and the leather boot goes underneath it to cover the shifter.

450 complete with throttle body sensor ,fuel rail

MEW1 eec-100 shifter 60 driveshaft-100+shipping 4r70w-350+shipping

does anyone know where the plug on the left side plugs into not the neutral saftey switch.

im doing a conversion from standard to the 4r70w. i have mostly all the parts i need.auto computer,stock shifter and cable.do all i just need to get is the optishift control? or will i still need to splice the harness up? The OptiShift Transmission Control System

email me at [email protected] or send me a pm with price and condition.

what all do i need to install a 390fe into a fox body.what k member should i use.im sure the c6 will fit right in.

who makes the harness for the s197 style maf to cut and splice into the factory maf wires? also who makes a tub k member that i can use factory a-arms.? i removed my manual transmission and installed a 4r. all i need is the ecu and get it programmed? i want to have push to start and remote...

19lbs yellow 8-30 stock 99-01 cobra injectors-50 lightning 90maf-50 2v professional adapter plates-125 00 anniversary wheels nice tires -300 99-01 cracked hood still looks good torch red-25 stock radiator-80 03-04 cracked rear led light-60 stock black leather front seats( best offer...

does anyone have knowledge on how to install a Fe engine in a new edge. im having second thoughts.either engine with be an auto.i would like a Fe engine punched out to a 428 or bigger but im not sure if it will clear my 3 inch cowl hood.and what k member mounts and headers i would need or where...

need it shipped to 77493.

what are some good setup that everyone is running.shocks,springs?...