Recent content by ez112

  1. ez112

    FS: L&S Oil Separator

    Well this was on my brother's truck for a while. He had to revert back to the lines, so now here this goes. $120 shipped?
  2. ez112

    I need a part number for this piece. :)

    It's the piece that goes back to the plenum from the PVC. In fact if anyone has a bunch of part numbers for the PVC line (especially the piece goes to the lower intake manifold in the back) please share! Thanks guise!
  3. ez112

    Electrial wiring diagrams/schematics needed

    Now without biting the bullet and getting a service manual, is there a place that has the diagram for a particular circuit? I'm having an electrical issues on a certain fuse and wanna try and trace it myself before I give up on this money pit and take into some place. It's a 99. Thanks a bunch!
  4. ez112

    ONE (1) 295/45/18 Goodyear F1

    I would say it has roughly about 60% tread on it. It's just been sitting here for a while and would like to get it out of here! $100 shipped? Thanks!
  5. ez112

    WTB: stock COP'S

    As the title says. Let me know what you got. Please be reasonable! :)
  6. ez112

    Same Coil pack keep BLOWING UP.

    Ok there is a list of possible finger pointing as to what COULD be the issue here, but I can't figure it out as to WHY that coil is the one the one that blows up. When it in FACT DOES blow up, the 30 amp in cab fuse that controls the ignition pops. #1 For the LONGEST TIME I have had been...
  7. ez112

    Ok...so I think I fried my PCM. Please confirm

    Moral. Don't ever buy Granatelli COP's. I've had NOTHING but trouble year after year with one after another going out on me, and then having to find where the misfire is. Ok. I was beating the crap of my truck because it's been sitting for a little bit. And the misfire I was having was...
  8. ez112

    WTB: 1999 Lightning PCM

    I live in Killeen, Texas so the closer the better. But I need one as soon as possible. Thank you!
  9. ez112

    1999/2000 Eaton M112 Supercharger

    This unit has about 94K miles on it when pulled. I upgraded to an entire 03+ Steggie setup so this has to go. I would consider this a nice for for a rebuild so I won't ask too much for it, BUT it does have a 2.8 upper pulley with INTERCHANGEABLE hub so $250 shipped? PM me with offers too...
  10. ez112

    So do I need gaskets?

    Howdy SVTP. It's been a long while since I've posted, but I've just been that busy and content with the truck! Well I have a 99 and doing an entire top swap for an 01+ blower. Midplate and all. So which of the gaskets are reuseable, or will I need an entire new set of intake gaskets...
  11. ez112

    I think I have a fuel pump problem. Need expert advice

    So my many bolt on Lightning runs rich. REALLY rich. I have a wideband and it says its in the 9's and you can smell it nicely under WOT. I never figured this many mods and I have a running rich problem.:shrug: I did a datalog and noticed my FPDC is at 1.00. It's ALWAYS at 1.00 and never...
  12. ez112

    Back of fog lights pic needed

    I have a 99 truck getting an 03/04 bumper. After doing a mock install it seems the old brackets for the fog lights seem to be different. Are they in fact different? Anyone have a quick snap shot of the back? Just curious. Thanks
  13. ez112

    WTB: Stock Torque Converter

    Has to out of a Mach 1 or a Mercury Marauder. Thanks!
  14. ez112

    Any automatic Machs with aftermarket TCs??

    Does anyone still have their OEM TC that they're looking to get rid of? I figured I'd try asking here first. Any links to one would be great. Thanks.
  15. ez112

    Winter VS. Aftermarket Heat Exchanger

    Well I'm a little worried I might be overdoing it with the cooling with that dual pass HE right now. What really has me worried, thought, what kind of cosmetic damage the winter might do to it as well. Anyone here run theirs throughout the entire winter (IN THE SNOW I MEAN not all winter...

Top