Actually your right Shadow Grey 03, the car seems to throw a hissy fit for a few seconds with shuttering and loss of power then eventually takes off without a huge increase in RPM. Not positive but doesn't seem like rear end is kicking loose. Car never did this prior to clutch install. I also...
Initially I thought that was the problem, but it's not. It pisses me off so much I'm afraid to race other cars on the street. I guess I'll make the trip back to Dallas and make the shop fix it.
Sent from my iPhone using the svtperformance.com mobile app
Recently had a McLeod 26 spline street twin clutch kit, Tremec 26 spline input shaft, LP throwout bearing, Ford pilot bearing, and a UPR quick click firewall adjuster installed by a reputable speed shop. Drove the required 500 mile break in period. Now when I go into boost there is an abrupt...
Recently installed steeda springs and HD upper strut mount on my 2012 BOSS. The strut mounts are capable of a camber adjustment of +/- 1 degree. Anyways the passenger side is good. I can make an adjustment of almost -2 degrees on the pass side. On the driver side I can only get -.5 degrees of...
I'm getting the Laguna Seca wheels for my 2012 BOSS 302. Having trouble deciding on front tire size. Should I stick with stock size of 255/40/19 or is 275/35/19 ok? I researched the topic a bit and realize quite a few people run that tire but no one comments on performance changes. I plan on...
Who is going to slap a pair of new Raxiom tail lights that resemble the LED brake lights of the 13-14 mustangs on their 12 BOSS. They will be available early Nov from AM. Hope I'm not the only one.
I just recently upgraded my SC and am putting down around 600 HP. I still have the stock clutch. I discovered a squeaking noise today that goes away when I step on the clutch. I assume my throwout bearing is making the noise. Not really knowing anything about clutches, should I replace my clutch...
Went to the dealership to purchase the black/silver key and have it cut and programmed since I did not receive one when buying the car. Anyways, that key works fine but now my red trackkey does not work. It starts the car but I do not get the track enabled message anymore. WTF did they do...
Just installed a 2.3L VMP SC with a 2.8 pulley size, good for 18PSI .I received a mail order tune for 93 pump gas. Finally put it on a mobile dyno and the results were not too impressive. Max HP 564, Max torque 480. I was hoping for more torque.
I have spent upwards of 10K on my cobra and numerous hours in the garage installing the parts and never place in local car shows. So who wins at these shows? Of course the president of the mustang club always wins. A tall pretty blond with a 07 Shelby GT also won. All she did to the car was...
I'm trying to install my new 18X10.5 TSW wheels wrapped in 315-30-18 proxes R888. Anyways I need to use a 1/4 spacer. I'm getting exactly 5 1/4 turns with my lug nuts on stock studs. The MM instructions say 6 turns minimum. Do you guys think I would be ok with only 5 1/4. This is a 03 cobra with...
Man I just picked up a steeda tri-ax for $92 plus free shipping, sorry I grabbed the last one. Also picked up some DBA 4000 series front and rear rotors for only around $300. You better check them out before all the cobra stuff is gone.