Im sure its been asked but if not here goes.
Can the output shaft flange of the 11-12 Tr-6060 be replaced with that of a 2013-14?
The pinion yoke on tje rear end is easy enough to replace wotj a Trinity peice
Sent from my SAMSUNG-SM-G930A using the svtperformance.com mobile app
Does the pinion yoke require replacement on a 2007-2012 for install of a 2013/14 CF shaft? I thought the earlier cars shared the same pinion cup attachment and it was only the front attachment that required a change?
I think there were two different ways of making the front work, there is an adaptor that attaches to the original 2007-2012 transmission yoke and then there was a person who machined a completely new yoke to directly install on the 2007-2012 splined transmission output shaft for 2013/14 CF driveshaft install.
"Back in the day", there was also a suggestion that a 2011/2012 trans yoke be used, replacing the 2007 or 2008-2010 yoke because the 2011/12 is a lighter yoke, but still retains the correct 2007-2010 output splines. <<This is if the "adaptor" was being used for the 2013/14 CF retrofit to the earlier car.
R
Last edited: