just curious. have a friend with an 90 gt vert with an on 3 single turbo kit. hes running high 12s @114. just wondering what most typical 500 rwhp ported eaton, full weight terminators run through the 1/4. may be a race in our future.
avg 1/4 mile mph for 500 rwhp cobra
- Thread starter matt87
- Start date
- Status
A good buddy of mine makes 499 rwhp with his IRS '03 coupe and runs mid to low 11s at 122-125 mph depending on air and temps....best runs have been on Mickey drag radials on stock rear 17s, with skinny 15s up front (running GT brakes).
My first passes on my ported setup were in the 11.0 range at around 126. It did have an SRA and bigs and littles on 28" ET Streets other than that it was pretty much full weight. Most at that power level are in the mid 11 range at over 120 without much trouble.
Last edited:
My last car would trap 126 with a posi port making a little over 500
Stock IRS, DRs, H&R Race springs, stock struts/shocks, Saleens reps, 505rwhp and 2000rpm launch it went 120.
Had my car to the track supposed to make 480 at the wheels but im just going from previous owner told me its a steggy stage 4 port 2.76 upper with banassi x pipe and dynomax cat back with h and r lowering springs rest is stock I drove 2 hours to the track with 18 fr500s let it cool down for about 45 mind but it was still pretty damn hot ran 12.1 @118 full weight 305/35 Mickey thompsons but I didn't do enough of a burnout and spun in first launched to high
11.5-11.6 at 126 with my car
posi port full boltons 2.76/4lb full weight 6peed irs 18 DR
posi port full boltons 2.76/4lb full weight 6peed irs 18 DR
Mid 11's at 122 to 123 mph depending on the combo!
505rwhp full weight stock wheels with drag radials in the rear. 118-120mph.
Pretty much identical to my old '03 Cobra. 11.4@123. 504rwhp, ported Eaton.
mid 120s full weight
Took mine to test n tune, 450hp/490tq Steggy stage 4 port, metco 4lb lower, JLT cai, SLP catback, Ford racing 4;10s, IRS brace, 18in AFS Cobra wheels and some worn out DRs launched @ 1500rpm ran a 13.1 @110 with 2.1, 60ft be advised track altitude over 5000ft..
Mine trapped 126mph with bolt on and ported blower,2.76 upper pulley. on IRS with 16" drag radials. Was making around 500 at the wheels.
Last edited:
With just under 480rwhp I would trap in the 123mph area.
519hp traped 128-129
I was trapping 123mph with nothing but 2.76 pulley, intake, exhaust tune. everything else stock and full weight.. no port.. so with 500rwhp a healthy cobra, with decent driving on a cool air should trap about 125-127mph.
I went 11.80 at 118 with BFG dr's. Full weight, irs. I was pullied only, making 457/507.
From memory I went a 11.21 with my first port at 121mph I think.
545hp went a 10.71@130+ with the 6 sod on big's n little's.
With the auto at 519hp with the same combo it went a 10.52@130+
With that setup and a 100 shot it went a 9.999 in the 1/4:thumbsup:
Weight was 3,750lbs with me in it.
545hp went a 10.71@130+ with the 6 sod on big's n little's.
With the auto at 519hp with the same combo it went a 10.52@130+
With that setup and a 100 shot it went a 9.999 in the 1/4:thumbsup:
Weight was 3,750lbs with me in it.
- Status
Users who are viewing this thread
