In for a set
Perhaps
But I don't have to tell you how hot and how cold the air is coming out of that vent which is going to be directed right at the back of the gauge while impeding the airflow. These are calibrated instruments, try touching it after a while getting blasted by the heater.
Not a good place to mount a gauge IMO
I know you said it would be about $275 a set back when it was like 3 of us, whats the price at now?
Fox body guys have been doing it for decades.
Perhaps
But I don't have to tell you how hot and how cold the air is coming out of that vent which is going to be directed right at the back of the gauge while impeding the airflow. These are calibrated instruments, try touching it after a while getting blasted by the heater.
Not a good place to mount a gauge IMO
how much are they?
Updated. Hopefully they will get a little cheaper.
I think the last price was $275 for (2) but that was with only a couple of us buying in. Now we have (26) vent pieces so hopefully we get a pretty nice price drop.
That's a lot of coin for a vent. And it must suck when using heat or a/c, just my opinion.
Updated Price.
For 30 Pods or 15 sets will cost 165 a set.
maybe I missed it, but didn't see it asked or mentioned, can you do these in ABS plastic or plastic like factory? It would reduce cost and look more factory. Anything billet is awesome, but just a thought
:banana:
where do I send the money to?
One step ahead of ya. :beer:
They are in ABS black plastic.
The price per piece in Billet was around 600 because of the 3D shaping.
Great, we are almost to our 30 vents right now.
Jason, did you want added to the list?
I think we should keep this open for another couple days then start accepting payment once we have our 30 minimum. To keep it simple, I recommend just paying in full instead of deposits.
When you are ready, Ironhand, post up your paypal address so we can get this rolling!
One step ahead of ya. :beer:
They are in ABS black plastic.
The price per piece in Billet was around 600 because of the 3D shaping.
So if they are ABS plastic, will they match the stock ones or will we have to dye them?