Search results

I had a bad luck streak through March that included my rear end locking up on the highway and wrecking my 98 Vert right after an engine build. That said, I have pulled a bunch of parts from the shell that I'd like to sell as quickly as possible. Most of the parts are large, so the listed...

Evening, all. Got the motor back in the car, trans bolted up, wiring harness run and (95%) connected. I was left over with this little guy: Any clue where this goes? I've got the cam sensor, coolant overflow tank and coolant sensor all hooked up on the driver's side, but I am...

I stretched my engine build so long that I am having trouble remembering where certain wires/vacuum lines go for sure. Instinct tells me that this is a ground wire that should go right on the engine. Can anyone confirm or deny my suspicion? As always, thanks in advance!

While piecing together my engine, I managed to break my stock reluctor wheel from my 98 4v. This seems to be a unicorn part, so no luck finding an exact replacement. I did a bit of reading and supposedly there was only one part used between the 2v and 4v engines, then they were later updated...

Well, I seemed to have screwed the pooch on my 98 vert, all because I wanted to install a fluid damper. Backstory: Picked up a March 1158 to replace an unknown set of UD pulleys that were on the car when I purchased. I've been eating through belts every 10k, so natural instincts told me to go...

Trying to reclaim some garage space, and the time has come to finally unload my old headlights. For sale, I've got a set of Depo projectors to fit SN95's, and a set of generic clear corners with black backing. The headlights are the same as these: Amazon.com: Depo 330-1120PXAS2 Ford Mustang...

Finally broke down and installed some Borla Stingers on my '98, so this set has to go. Complete piping and polished tips, however I came up short on one U-bolt clamp, and the tips could use a polish. Other than that, this set sounds nice, and the only reason I upgraded was because I wanted...

I recently got the drive to install my Maximum Motorsports Caster/Camber plates that have been sitting in my garage for the last two months. Everything seemed to be going well during the install. The instructions, by the way, are very nice, even though I found the blow-up illustration to be...