Recent content by SVT12GT500

Hey, Im trying to find research on adding cooled seats to my 12 GT500. I was wondering if anyone knows if you can add the cooling part to the leather seats in the GT500 and if there is any write ups about it. Thank you so much in advance. All the information that I am seeing is for adding new...

Ok sweet. Thanks guys.

Hey guys, I have been putting a kit together with: 2.8LC KB, JLT CAI, probably a 75 MM TB and O/R x-pipe. I was wondering if I could use this set up with a custom tune and then later add a BAP and/or injectors or would it be too much of a risk with the fuel?

Thank you Sonic

Hey everyone, I am looking at getting a Lund NGauge for my 2012 gt500. Does anyone know or have a link to what sensors the NGauge can read on a 2012 GT500 and how many can be hooked together?

Thank you

Thank you guys. Is it possible to run very little or even no meth up to a certain psi and then at a certain psi the meth will open up?

Does anyone know definitively where it is best to spary meth into a 5.4L with a TVS for higher octane? I can not find a post that can state for sure pre blower or post blower. Thank you in advance.

Thank you guys for the update. So, it might be possible depending on how good the tune is. I'll have to talk to the tuner that is near me then...

Thank you guys for the posts. I was under the impression that the smog test for newer vehicles was done with the computer system so i thought that the tune could help alot.

Hi Everyone, I am trying to do some research to see if it is possible to install cams and at what stage in order to be able to pass smog in California. Does anyone have any experience with this in CA? I did some searching but nothing specifies CA. Can you do something like install the cams...

Is anyone running the setup: Stock ported blower, full bolt ons, and aftermarket cams (2011-2012) ?I am curious what kind of hp numbers you have.

Does anyone know for a 2012 stock ported blower, 10% lower and either a 2.6 upper pulley or 2.8 pulley what the boost psi is going to be at sea level?