Meth and Octane

[SVT12GT500]

Does anyone know definitively where it is best to spary meth into a 5.4L with a TVS for higher octane? I can not find a post that can state for sure pre blower or post blower. Thank you in advance.

 

[Willie]

For an octane boost, it does not matter where you spray.

 

[DavidHasselhoff]

Back of the blower...Get some ports welded into the rear housing of the blower. Steggy did it on mine.

 

[SVT12GT500]

Thank you guys. Is it possible to run very little or even no meth up to a certain psi and then at a certain psi the meth will open up?

 

[sleek98]

Yes use a Hobbs switch. At a certain psi it will turn on.

I can't remember what switch I used on an old eclipse I had but it was the same setup as a Hobbs just a little different packaging. The meth kits maker usually sell one in their kits

 

[Willie]

I use Julio's controller>>
https://www.alkycontrol.com/
with a two-stage 250-psig pump.
5-nozzles.

 

[DavidHasselhoff]

Notice the 2 ports in the rear of the blower. Alky control is what I'd recommend too.

 

[SVT12GT500]

Thank you

 

[V8Flexin]

Is the snow performance kit any good?

 

[Willie]

Do you like plastic lines?