Recent content by MouTine

'05 CLK55 sold. Now '04 SLK55.

...or actually traded it for '92 850 Cia Bimmer. I just want to say thank you all. You guys helped me a lot with all the probs I had. There wasn't many of them. Mustang worked quite well in all these five years. Anyways... Thanks and goodbye. =)

Quick question... Can I pull away cylinder heads with stock headers still atached? And can I put heads back with shortyes allready installed? Thanl you.

Me and puch of other car maniacs (8 cars, 16 ppl) made a litle one week roadtrip few weeks ago. We drove from Finland to Germany into legendary Nurburgring racetrack. It was pure fun drive tru Sweden and Denmark midle of night. Over all length of the trip became something like 4000km (2500mls)...

Just want to show you all a litle video friend of mine uploaded on YouTube... YouTube - ‪Ford Mustang incar @ Ahvenisto 21.5.11, Cosworth & RS Club trackday.‬‏ It was fun weekend.

Yes did try search with no luck. Could someone please post here a direct link to the topic where some expert explained very well throuly what hapens in tune when IMRCs work. There was some writeing about timeing adjustments and what should do when deleting IMRCs and common misstakes that...

Is it good or bad thing to delete EGR system? I suppose that EGR system lowers the combustion chamber temps and so disableing it from the tune could couse detonation. Right?

Yeah, how to remove that panel where those three control knobs are? And does anyone have picture of backside? I'm planing to install two small switchses into that panel. Tnks ppl!

As title says. If you know any, let me know or want make a short visit to scrapyeard to help me I would be very happy. I would love to have those US lights for my winter-ride. Thank you! moutine (@) nic . fi PM

How loose the both cables are when ports are closed / not operating? Simply when you stick your hand behind the engine and reach cables how does it feel? How much there are loose play in bare cables? I mean between wire outershell connecting point and connectingknob in IMRC turning elbow. Not...

Well... Long story short. I have been bit bored on my Cobra lately. Tryed to sell it for a while with no success. Car feels and runs good but the fact is that it is 150k engine with minor oil breathing between heads and block and all kind other things that come along with that mileage. Ok...

Quick question... Does Lightning shaft fit into our block without probs or major mods? Ford Racing M-6303-M54 - Ford Racing Steel 5.4L Lightning Crankshafts - Overview - SummitRacing.com

Can main bearings been changed underneath while engine is in car? I mean same way like rod bearings. If crankshaft is hanging by front and rear seals and tranny is supported, is there room enought to slide top bearing halfs away and install new ones? Or did I just got major brain fart?

Filling up coolant soon and now I'm packin thermostat housing... What direction should that tiny ballhole in t-stat pointing?

Just reved to the limiter and it didn't came off when running.