So several of the lights in my gauge cluster weren't lighting up. I pulled the gauge cluster and removed the printed circuit board. I found an area of corrosion on the board. I have ordered a used 2003 Mustang GT 5-speed cluster off of eBay. It uses the same exact circuit board. If I swap...
This is the second time I will have to peel the seat cover up on the driver's side seat to put the lumbar support bladder back in place. What I found when I re-seated the bladder the first time is that there is a little plastic tab on the bladder that fits through a matching hole on the plastic...
Got mine yesterday. Interesting article on the new Shelby GT500. I would recommend holding on to this rag...it might be worth something someday since it explains the demise of SVT and the merge with Ford Racing. Discuss...
I visited with the same dealer (Don Davis Ford) this weekend that I ordered my '03 Cobra from back in '02. I asked him how many Shelby GTs he was going to get. He stated they were going to get 4 of them and that all of them were going to be sold to the highest bidder. No orders for these cars...
The other night I left my Cobra outside (usually I put it in the garage) which means it was exposed to colder temperatures than normal. The next morning I started it up and pulled it into the garage. As I get out of the car to walk behind it to go inside the house I see a huge trail of oil...
I just finished putting heads and cam on my 1990 GT. I went with the Performers with the thermactor plugs installed in the heads (smog pump lines plugged). The smog pump is still on the car but is only feeding the line that runs down to the H-pipe (currently has an off-road H). The other line...
Ok...I'm changing the oil today in preparation for the SVTOA on track event "Fall Thunder in the SouthWest" next weekend. I figure I'll drive up on the 'ole ramps and check out her ass.
So, recently I purchase the shop manual for the '03 mustang and I also purchased the paper copy of the TSB...
My Cobra got rear ended recently and the Ford Dealership body shop had to replace the rear bumper cover and the styrofoam shock absorber that is between the bumper cover and the metal bumper. Can somebody tell me how the styrofoam shock absorbing buffer mounts to the metal rear bumper?? If you...
I pulled code PD0190 today. The Fuel Rail Pressure Sensor has gone bad. Is there a schrader valve somewhere in the system that I can bleed the pressure off the system from? I couldn't see one. How do you make sure the system is de-pressurized. I don't want a faceful of fuel when removing...