Recent content by gotmach1224

I have an 05 Mustang GT with a GT500 fuel system. Does anyone have a wiring diagram for this? I'm running the dual boost-a-pump. The link for blow by racing doesn't work and to my knowledge it's different anyways compared to a GT500. Any info or pics would be great thanks.

anyone on here running an on3 forward facing set up? if so can you post pics of how you have your drain setup ran. Would really help me out completing my car thanks

I need to make sure my wiring is correct. Went from typical maf on a 00GT to a slot style maf. So i need to make sure the IAT is in the right spot as well as power and ground. Does anybody have a diagram i can go off of that they trust. I looked one up on google but I'm not sure if it is correct

Alright so I have a 2000 GT. Parked the car 9 months ago to start my turbo project. Finally finished the car yesterday and tried to start it for the first time. The car turns over but will not fire. Problems; I left the battery out of the car for those whole 9 months, also when I turn the key I...

i recently picked up a new boost brothers kit. i have plently of mechanical experience but this kit came with the lack of any instructions. has anyone ever installed this kit and have any pics they can post up. main thing is mounting the intercooler and where to tap the oil pan for the return...

Alright i just bought the NX plate system for my mach. The directions it comes with are for a nozzle set up not a plate kit and also when you install the plate the original shaker bracket is no good. My question is has anyone installed this kit or something similar that can upload some pics to...

putting nitrous in the mach next weekend and aside from a nitrous pressure gauge what other gauges are good? i was thinking fuel pressure would be something good to monitor while spraying the car. whats everyone else using out there?

Whats up guys...Im running a steeda tri ax right now and not really liking it. Whats everyone else running and your thoughts? The only other short throw ive felt was a pro 5.0 and i really liked it. I'd like to get some input from everyone else though. Thanks!

I installed a P1SC kit on my friends mach 1. I uploaded a tune from Dez that was emailed to me to get the car drivable, problem is the car has a really choppy idle. I also noticed that the stock mach 1 maf sensor has a built in IAT sensor and the lightning 90mm mafs do not. I swapped the sensors...

so I have all the trans bolts out, all wire harnesses etc. crossmember is out dust cover bolts & starter are gone. I can only seem to get the trans to move off the motor about a 1/2" if that. any tips or tricks to get this thing out. ive been going at it for days now and no luck. any help would...

My 3rd gear in my tr3650 is grinding. when the car is cold, and you baby shift it goes in. once the car warms up(tranny) however or you try to jam gears it grinds bad. after about 30 miles of regular highway driving yesterday it wouldnt go into 3rd on the downshift until i let the car cool...

anyone have a meziere elec water pump? looking to get some pro's & con's on this mod. I heard it can give you 11.5 rwhp so I was just wondering if its worth the money or people have had a lot of problems with these failing. any feedback would be great thanks

so in between shifts my car hangs r's a little bit. not to bad but should be coming down a lot quicker. I cleaned the IAC valve but it still is doing it. any other suggestions ?

I'm rebuilding my entire rear end. anyone with opinions on the choice of axles to go with?

just wondering some of your guys power numbers on a fully bolted on Mach 1. I have MAC longtubes o/r x Bassani cat back JLT ram air and throttle body. just curious to see what ill make with a good tune?