Cant remove trans HELP!!!

[gotmach1224]

so I have all the trans bolts out, all wire harnesses etc. crossmember is out dust cover bolts & starter are gone. I can only seem to get the trans to move off the motor about a 1/2" if that. any tips or tricks to get this thing out. ive been going at it for days now and no luck. any help would be great. thanks!!

 

[Mystic-SVT]

Clutch cable out?

Get a pry bar and start prying.

 

[MachJoe98]

Yup. It's a pain in the ass, pry bar and an extra set of hand definitely helps

 

[4v_mach1]

I had to twist mine left/right and pry the f&%k out of it.. and this wasn't done alone. I had someone help me hold it in place on the jack as I was prying it off.

 

[Icecold]

From the bottom of the engine jack up the front of it maybe an inch or a little more ...so that the rear tilts downwards, that might help get it out, ive done trannys 5-6 times now on the sn's its not a lot of fun but never really had a problem getting them out always getting them back in due to the tightness of the fit and tring to get the damn input shaft in/lined up, but by tilting the rear of the engine down just that little bit helps out lots !!