The clutch cable is Ford part number 2R3Z-7535-AA and still in the original packaging. Retails for over $90.00 and much higher quality than aftermarket cables (won't snap). My clutch cable turned out to be perfectly fine so I don't need this one. Fits 03-04 Cobra. $70.00 + Shipping
Lethal...
Put the car on a lift recently to check things out. Found a bit of oil collecting on a bolt which faces the alternator. The car doesn't leave any spots when it's parked. Oil level looked fine, maybe slightly low on the dipstick, but nothing alarming. Has anybody found something like this? This...
I want to cover this and protect it so the exposed metal doesn't begin to rust. It's around the inner edge of the trunk near the weather stripping. I'm thinking a rhino liner style coating - any suggestions?
Click to enlarge.
Click to enlarge.
I really, really want to track the Cobra this summer. The car has no suspension modifications or upgraded differential cover, and is also on the stock 10-spline input shaft. The car makes 450RWHP/457TQ on a dynojet. It currently has Sumitomo's (Ewwww) all around.
This is a daily driver for...
Okay, whoever put the inserts on the rear bumper of my car must have been stoned. Seriously, look at this:
It looks pretty tacky at most angles, and the sloppy placement is especially noticeable up close. Is there any way to safely remove and re-seat these inserts without damaging the...
The damage:
The emblem and fog light bezel aren't much of an issue. They can be replaced. However, the tabs where the bumper connects to meet the front fenders are both busted away. Also, the driver side "post" in the lower grille is broken at the top. Can anybody provide some insight on how I...
Hey guys, I've been lurking here for a little while and finally picked up a car. This is the best forum I have been on yet.
I am 22 years old, full time student and full time employee at a Ford dealership as an "Internet Sales Specialist." Basically, I take pictures of vehicles and put them...
Looking for an engine/tranny combo with enough supporting hardware for a swap. Wiring harness included would be nice.
Send me an email at G.egebrecht "at" gmail "dot" com.
- Glen