Okay, I went to NGK's website.
For an 03 Cobra, their standard replacement plug is listed as TR55.
For an 04 Cobra, their standard replacement plug is listed as TR6.
Anyone knows what the difference is besides the part #? :shrug:
WC
Anyone knows what is the paint color code and paint brand for the stock plenum and blower. Trying to repaint plenum and can't find a good color match.
Help much appreciated.
I think there's a gasket for the TPS but not sure whether there's a gasket between the TB and plenum and one between the plenum and SC.
Any help would be appreciated. Wanted to pick up a set of gaskets before I start in case I ruin the one's in removing my old TB/plenum.
Thanks.
Anyone out there has a 93-95 Lightning rear bumper for sale?
Mines got crushed by some drunk. Prefer black but must be in very good condition.
thanks...WC
Hey folks,
My boss has an 01 L and what's to install a full Bassani exhaust system....headers to cat-back.
He's running a smaller upper, a CAI and chip.
Any thoughts and places with good prices?
Thanks...WC
Okay...
I did the boost gauge overlay a week or so ago and the install went perfect. Got into boost a few times but really didn't peg it.
Installed a 2.93 pulley yesterday and the Predator pulley tune. Again got into some boost and had some pinging. Richened the A/F by 15% and it seemed to...
Okay folks...
Just want to make sure I got the fuel and timing adjustments right. If I want to make my A/F richer I move the Predator to Rich on the scale even thought the percentage goes all the way to a -15%.
On the timing, if I want to retard the timing I'm going to go with a negative...
Just dyno'd car for first time.
Mods:
Magnaflow catback
Densecharger
3.2 pulley
Cooled down for about 15 minutes; 87 degrees outside.
Pull #1 410rwhp/400rwtq
Pull #2 415rwhp/405rwtq
A/F was low 13's up to 3500rpm then down to low 12's high 11's
Slight dip at about 6000 rpm...
Ordered a gel overlay from SVT CUSTOMS and....
1. Got my order two weeks later which was wrong;
2. Returned them via priority mail over a month ago and they keep saying they never got it.
3. They said they were sending out the correct one anyway but it's been another three weeks.
Anyone...
Took the paint off the inside of my chrome rims using lacquer thinner. Decided to do just the 2.5" lip behind the spokes.
30 minutes each including cleaning and polishing time.
Looks a lot better. Thanks for everyone's input in prior threads:-D
Trying to get a picture posted but my...
Any suggestions on a vendor to pick up a full Bassani exhaust system for my 94L? West Coast would be preferable since I'm in the middle of the Pacific Ocean.
Feedback appreciated.:-D