I just pulled the trigger on this item! Can't wait to receive my new LEDs H/L and Fog combo!
http://www.ebay.com/itm/26151417665...em=&sspagename=ADME:X:RTQ:MOTORS:1123&vxp=mtr
ships from Hong Kong....
I just pulled the trigger on this item! Can't wait to receive my new LEDs H/L and Fog combo!
http://www.ebay.com/itm/26151417665...em=&sspagename=ADME:X:RTQ:MOTORS:1123&vxp=mtr
ships from Hong Kong....
no ballast...bulb only....Ill take a pic later today
From my understanding the H10 bulb is the same bulb as a 9145/9005/HB3 etc etc....I contacted the seller (the one you purchased from) and they said that a 9005 LED should work for our fogs. I previously ran a 9005 HID and it fit in the housing fine. Here is the link to the new 2014 6400LM 9005 LED Bulb:
http://www.ebay.com/itm/26151417665...eName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649
I am waiting for the seller to get back to me because I want to order both the High Power Headlights and Fogs....Almost $200 in lights but most likely it will be worth it over lifespan, quality, etc
Ever get the pic? Trying to determine if they'll fit with my KC gear. Are these the bulbs you have? http://www.hidguy.net/2003-2004-ford-mustang-svt-cobra-fog-lights-led-upgrade/ V1 or V3 and what color? Thanks
Can you take a pic of the fog LED bulb next to your current fog light bulb and OE bulb if you have it? I'm trying to figure if the LED is going to clear my KC gear. Also get a pic sitting in the car of headlights only, I'd like to see how much brighter your 2600's are compared to my 2200's.
Ever get the pic? Trying to determine if they'll fit with my KC gear. Are these the bulbs you have? http://www.hidguy.net/2003-2004-ford-mustang-svt-cobra-fog-lights-led-upgrade/ V1 or V3 and what color? Thanks
Can you take a pic of the fog LED bulb next to your current fog light bulb and OE bulb if you have it? I'm trying to figure if the LED is going to clear my KC gear. Also get a pic sitting in the car of headlights only, I'd like to see how much brighter your 2600's are compared to my 2200's.
So my H/L and Fogs are in CA, should hopefully be here within about the next day or two! Super stoked!!!!
UPDATE
I got the retainer rings trimmed down and working just like stock. You can see in the pics how much was removed (left piece), that's all you need to do. The piece on the right hand side is what is used for retaining the bulb in the housing as in the bottom pic. below. I used a dremel wheel from the inside and set the cut as close as possible to the tabs that hold the bulb in. I did that for each tab than finished cutting from the outside. Works like a charm. I haven't been able to adjust the beam yet as its been raining but I don't see any reason it would be any different than OE.
This cleared up alot. Thanks guys.
^^^ Pics now! :-D Cell phone camera no flash so we can compare please.
^^^ Pics now! :-D Cell phone camera no flash so we can compare please.