Powered by corn results!

thgt500

Member
Established Member
Joined
Dec 22, 2011
Messages
558
Location
Texas
Finally got to dyno on the corn:

Blower only results are 798 rwhp & 879 rwhp with blower and a 50 shot. :banana: I am VERY happy with these results @ only 21 on timing. We spun a little on the blower only run....so low torque and probably would read a lil higher on hp. I was impatient, and we had to change to E85 jetting. We hit it again and the dyno didn't record so we went right on to the 50 shot run. TEXAS MILE I AM READY! Still have to switch to stiff springs, speed balance wheels and tires, put front sway bar back on, and wait.

http://www.svtperformance.com/forums/svt-shelby-gt500-150/905273-going-e85.html

16iaxaw.jpg


359ahys.jpg


Screeny of the log of NOS run.

352k9s0.png
 
Last edited:

thgt500

Member
Established Member
Joined
Dec 22, 2011
Messages
558
Location
Texas
LOL, will be bigs and littles with MT's at the track. Hoping to crack a 9 here soon before we switch all the stuff for the mile.
 

rdsnk46

Active Member
Established Member
Joined
Apr 9, 2005
Messages
5,599
Location
florida
Loving the corn on my Termi swap! How much boost?
 
Last edited:

Van@RevanRacing

Active Member
Joined
Feb 24, 2008
Messages
6,964
Location
S. Florida
I'm happy to say I've been a part of this build. I'm also happy to say that I will be co-driving this mutha at the Texas Mile. Gonna be a good time T-!!

Make sure we talk about the chassis and suspension before you proceed with final set up for the mile.
 

thgt500

Member
Established Member
Joined
Dec 22, 2011
Messages
558
Location
Texas
I'm happy to say I've been a part of this build. I'm also happy to say that I will be co-driving this mutha at the Texas Mile. Gonna be a good time T-!!

Make sure we talk about the chassis and suspension before you proceed with final set up for the mile.

Will do bud! CAN'T WAIT! :beer:
 

thgt500

Member
Established Member
Joined
Dec 22, 2011
Messages
558
Location
Texas
Damn that's nice! What are your mods?

MOD LIST:

2.9L FRPP Whipple 2.875 Upper pulley
Full Return Fuel System custom lines/405 pumps
105 injectors
NGK TR6 plugs
SuperCobra Jet Oval Throttle Body
Thump Tensioner
Gates green Belt
Metco 90MM Idler
Innovators West 10% Lower Pulley
JLT 127MM CAI
JLT Passenger side oil/air separator
JLT Drivers side oil/air separator
C&R Dual Fan/Dual pull Heat Exchanger
Rousch Larger stock look reservoir
Aeroforce Interceptor with 3.5bar sensor
Barton Shifter
Dynatech headers
Custom H-pipe
Flowmaster Outlaws = INSANELY LOUD.
BMR upper control arm and mount
BMR Driveshaft safety loop
BMR Lower control arms
BMR Anti Rollbar
1 Piece aluminum DS
Strange adjustable front struts
Qa1’s adjustable rear shocks
Cobrajet springs Drag - (NON LOWERING)
SVTPP Springs for The Mile
 

Users who are viewing this thread



Top