Belt setup is
2.75 RR
Larger Alt pulley (not sure exact size, Hermann put it on)
4 lb Metco lower.
100mm Billetflow idler
When we hooked up a boost guage I would hit 18psi, but it would drop to below 12 by the time I came near the redline. (beltslip? I think so)
Problem is Hermann put on a 810 Gates and its slipping bad(I believe & so does Rick). Tried to put on a 796 Gates. Would not fit.
Tried a 805 Dayco and that would not fit either. To small.
So what is next? Do I need the billetflow tensioner? :whine:
2.75 RR
Larger Alt pulley (not sure exact size, Hermann put it on)
4 lb Metco lower.
100mm Billetflow idler
When we hooked up a boost guage I would hit 18psi, but it would drop to below 12 by the time I came near the redline. (beltslip? I think so)
Problem is Hermann put on a 810 Gates and its slipping bad(I believe & so does Rick). Tried to put on a 796 Gates. Would not fit.
Tried a 805 Dayco and that would not fit either. To small.
So what is next? Do I need the billetflow tensioner? :whine: