Sounds like Tim is shooting for 750+ and the VMP big dog spot! :beer:
"Official" VMP TVS owner thread
- Thread starter bad93svt
- Start date
Jake is the "Big Dog" and will be hard to beat.
I am currently the 2nd fastest VMP TVS powered Cobra.
That wont last long though. There are to many folks boosting up and looking for big numbers and low track times.
I LOVE it!!!
Not taking credit from jake, but my reference was in terms of street driven everyday cars! Not purpose built race cars.
The addiction is what drives us all! Never good enough!
LOL....I don't get caught up in Dyno numbers .... The other slip is all that really matters :burnout:
Jake's car is just BADASS :rockon: .... No Joke!!!!!!
Jake's car is just BADASS :rockon: .... No Joke!!!!!!
Last edited:
Can't wait to see your results Tim! No 600hp 11sec car for you! Straight to the 9s! :banana::rolling:
Thanks :beer: ....hope to have a few boxes of parts today or tomorrow / then the fun will begin!!
My 10 sec. Eaton has been fun
epper: ... and I haven't seen 550 rwhp yet Thanks :beer: ....hope to have a few boxes of parts today or tomorrow / then the fun will begin!!
My 10 sec. Eaton has been fun
The fun part is trying to put all the new found power and gobs of torque to the ground!! :burnout: :burnout: :burnout:
Torque.... What's this word you speak of Rick? Lol
Every combo is a little different .... go for the 2.8" with the E85
Hope to have a few boxes today....
Hope to have a few boxes today....
well its time for a stalled auto Rick so you can put her on the bumper!
If I had the extra funding I would definitely like to go auto.
placed my order today.Went with the big elbow,3.0" pulley for the street and 2.6" for race gas.Now just need to order up the SCJTB.
Sir, yes Sir!!
Awesome!!!
If you have any install questions please let me know.
Rick
Can the plenum on a TVS be installed with the supercharger on the car? My body from out of town is helping me install mine, but I am not sure if the plenum will be here by the time he will be in town.
Yes it can.
The elbow has the same configuration as a stock Eaton.
There are 4 bolts holding the elbow on. Remove the two top bolts, loosen the two bottom ones and the elbow comes right off.
Install in reverse order.
Make sure to keep an eye on the rubber O ring so that it doesn't get knocked out during the install process.
If you or your friend have any questions let me know.
Rick
Last edited:
Cool beans, Thanks Rick, I will let you know if I have any more questions.
Users who are viewing this thread
