- Joined
- Jul 4, 2017
- Messages
- 986
I use my track packed '13 for driving fun, both on the street and at HPDE's. No commuting or road trips with the wife. So far, I have FRPP L springs, FRPP front sway bar, BMR front a arms, LCA/re-lo brackets and Watts Link, Griggs Torque Arm, stainless brake and clutch lines, Dot 5.1 fluid, Shelby Venice wheels with Nitto 555 G2's, 285/35 front, 305/35 rears. I will drive it through this HPDE season in this configuration unless something breaks or wears out.
The next off-season I plan to add a VMP Stage 2 kit, MM k member, ARH headers, upgraded heat exchanger and radiator, tstat, oil separator and a brake cooling kit.
When the 555 G2's are shot, I will get a set of Vorshlag 19x11 wheels and wrap them in NT01's, either 305 square or 305 front 325 rear. When the OEM rotors are shot, I will upgrade to either Eradispeeds or RB 2 piece rotors. When OEM dampers get squishy, I will go with JRi or KW V3's, with a chance I'll do Vorshalg's Trackpro kit instead.
The next round will be to add a KB Bigun IC under a VMP G3 and perhaps upgrade to the MM SLA system if/when that comes out.
Should be a nice, progressive build, coupling things that go together (k member/header install, VMP G3/IC install) that will give me a very capable car that I hope to get enough seat time in to grow into.
I welcome thoughts/suggestions.
The next off-season I plan to add a VMP Stage 2 kit, MM k member, ARH headers, upgraded heat exchanger and radiator, tstat, oil separator and a brake cooling kit.
When the 555 G2's are shot, I will get a set of Vorshlag 19x11 wheels and wrap them in NT01's, either 305 square or 305 front 325 rear. When the OEM rotors are shot, I will upgrade to either Eradispeeds or RB 2 piece rotors. When OEM dampers get squishy, I will go with JRi or KW V3's, with a chance I'll do Vorshalg's Trackpro kit instead.
The next round will be to add a KB Bigun IC under a VMP G3 and perhaps upgrade to the MM SLA system if/when that comes out.
Should be a nice, progressive build, coupling things that go together (k member/header install, VMP G3/IC install) that will give me a very capable car that I hope to get enough seat time in to grow into.
I welcome thoughts/suggestions.