I pulled out the 22’s (gap ~ .43) and installed autolite ar103’s(copper / same heat range as 22’s)
Gap was set @ .40 for the new ones installed
I would like to increase the gap without getting blowout
How far can I go, I think ford says up to .46
I know there are still some stock pulleys out there, so please let me know what gap has produced good results.
Gap was set @ .40 for the new ones installed
I would like to increase the gap without getting blowout
How far can I go, I think ford says up to .46
I know there are still some stock pulleys out there, so please let me know what gap has produced good results.
Last edited: