Crank keeps spinning

[Murderedsvt]

Any suggestions, trying to remove lower stock caged pulley keeps rotating, I have the ebrake maxed out and in 6th gear, doesnt help the car has a slipping cluctg im sure, car has a innovative west damper on it and was told I can't run a metco lower pulley out on the hunt for a stock caged lower too. Any help will be appreciated car has been kicking my butt lately

 

[RichM1983]

It has been years since I've owned my 03 and removed the lower pulley. If I remember right the lower pulley bolt is reverse threaded. Also make sure you remove all the bolts and nuts holding the cage to the block.

 

[03' White Snake]

Put a pipe or bar on one of the tri spokes of the pulley and hit it with a sledge. The shock will get it loose. Remember, reverse thread!!

 

[P49Y-CY]

use the factory service tool: rotunda 303-673.

 

[FleeMan]

Much cheaper option and works just as well. I own this tool as well.

Ford Modular & Coyote Flywheel & Flexplate Holding locking tool [T1600] - $31.99 : Modular Motorsports, Home of the worlds fastest Fords

Modular Motorsports Ford Modular & Coyote Flywheel & Flexplate Holding locking tool [T1600] - Great for removing and installing stubborn Harmonic Balancer bolts, flywheel & Flexplate bolts & Torque converter bolts. A tool that EVERY racer needs!! *Bolts in place of Starter to lock crankshaft in...

www.modularmotorsportsracing.com

 

[MG0h3]

The rear wheels are still on the ground right?





Sorry….had to.

Sent from my iPhone using svtperformance.com

 

[2003RedfireVert]

I have a 3/4in breaker bar for this. That tool FleeMan posted is probably going to be something I’ll order too.

Good luck.

 

[Murderedsvt]

I'll probably have to order that tool, tires are on the ground also lol

 

[olympic]

Put a little heat on it.

 

[Murderedsvt]

Put a little heat on it.

It just spins the whole balancer

 

[hotcobra03]

I've used a bar thru driveshaft yoke to hold as tool does .

You need a long bar also on breaker