My car will not start after I installed a Paxton tuner kit with id1000s and vortech universal bap. It is getting spark but it is not getting fuel. Checked all fuses and they are fine, fuel pump is priming and there is fuel getting to the fuel rail. Pulled spark plugs and they are dry. The car just turns over and won't start. I put it back to the stock tune and it does the same thing. Any ideas?
car wont start after paxton install
- Thread starter busarich
- Start date
Check the ground for the injectors/harness.
update signature to stock with paxton and car will start
Haha I wish
I checked it and rewired back to stock does the same thing primes and has fuel at the rail. But doesnt squirt.
MAF plugged in?
Yeah i checked that as well.
Alright so I checked the ground on the front of the passenger side head, the one where the new coolant reservoir goes and for a ground signal to the injectors. The 2 grounds are good but the injectors are not getting a signal white trying to start. I am not in anti theft mode either. Im running out of ideas.
Have you checked for dtc's?
-Thomas
-Thomas
Cam sensors are in the top front of the valve covers? The crank sensor is on the back of the motor? But not entirely sure where
Check all fuses?
I used to live in Dixon, when I was stationed at Travis. Yeah I hooked up the sct and looked for codes and nothing
Yes sir. Nothing was blown
Check grounds on bap and ensure you're getting power. Check inertia switch in trunk. If no luck then disconnect bap, hook up fuel pump wiring as it was stock and re-attempt starting. Can you hear your fuel pump priming when the key is turned?
Users who are viewing this thread
