BWNBYU"s First Mod Motor = Vortech Air to Air and much more

98 Saleen Cobra

Well-Known Member
Established Member
Joined
Feb 28, 2007
Messages
19,524
That L is one bad ass truck!!

It's funny I was going to mention the exhaust, but remembered how big of a PITA my Panhard bar was. And then I did a custom setup and looked awesome. Until I hit a bump and ****ed it all up ahaha
 

Blown_By_You

Richard Head
Established Member
Joined
Sep 22, 2005
Messages
7,613
Location
Montana
That L is one bad ass truck!!

It's funny I was going to mention the exhaust, but remembered how big of a PITA my Panhard bar was. And then I did a custom setup and looked awesome. Until I hit a bump and ****ed it all up ahaha
Gotta have time to build it. Tough crowd!

Sent from my VS987 using Tapatalk
 

Deceptive

Muffin is my spirit animal
Established Member
Premium Member
Joined
Feb 10, 2011
Messages
13,580
Location
Nashville, TN
On my Cobra I am going to have the exhaust routed over the axle like normal but remove about 3-4" out of where it drops . I am then going to have it routed towards the back then a dump type setup angled down and away so that you do not see exhaust after the axle.


Sent from my iPhone using Tapatalk
 

Blown_By_You

Richard Head
Established Member
Joined
Sep 22, 2005
Messages
7,613
Location
Montana
b7001cc1d91e82e768dca9efc0f14122.jpg


Sent from my VS987 using Tapatalk
 

2DXTRM

Pushrod 5.0
Established Member
Joined
Sep 17, 2008
Messages
2,422
Location
Some time zone
That red car gets better and better. I hope the white one isnt being left out.

Was that the Brembo kit from FTBR?

What audio components are they? Complete removal of the Mach 460?
 

Blown_By_You

Richard Head
Established Member
Joined
Sep 22, 2005
Messages
7,613
Location
Montana
That red car gets better and better. I hope the white one isnt being left out.

Was that the Brembo kit from FTBR?

What audio components are they? Complete removal of the Mach 460?

It's the Full blown Brembo Gran Turismo Kit.. Yes, FTBR sells it for $3200.
All Mach 460 has been removed. The speakers are Focal Components. Very nice stuff. I will be remaking the rear seat delete and covering it in vinyl. Unfortunately I'm out of room to hide the amps, so they will go on the bottom part of the RSD. Will look really clean when I'm done regardless..

Made a bunch of headway today..
New Black ACC Mass back carpet is installed.. Put most the interior back together so I can remaked the rear seat delete.. Finished the battery wiring with tech flex in place of wire loom.
Tomorrow the Torque Arm shows up so I can fit it as well as the new hood.
 

bullitt_11

Member
Established Member
Joined
Feb 16, 2009
Messages
143
Location
Columbus, IN
Awesome build man. Been following this for awhile now.

I have been looking into switching to air to air for a while now. What size intercooler piping did you use? 3"?
 

Blown_By_You

Richard Head
Established Member
Joined
Sep 22, 2005
Messages
7,613
Location
Montana
More parts showed up today.
MM torque Arm.
MM racing upper rear shock mounts
Cervinis Hood
And some other shit
2dd8bbb1d2114192053bd4051db25498.jpg


Sent from my VS987 using Tapatalk
 

Users who are viewing this thread



Top