SVT_GAL said:This modification works well. This minor modification is what separates the boys from the women!
Exactly! Even 5 more horses helps but i would guess it would lower temps a bit and speed up air flow.
SVT_GAL said:This modification works well. This minor modification is what separates the boys from the women!
You still can?! :shrug: :??:FSTMRFR said:I agree, I should have posted it
brkntrxn said:I don't doubt you have gained horsepower from the mod, what I am asking for is for you to quantify the 36rwhp by showing us before and after dyno sheets.
Juiced-03 said:You still can?! :shrug: :??:
Talk is cheap, prove your mod works! Not a flame towards you, but it just seems like you are hiding something. Prove me wrong.
02GTKB said:sorry but I cant belive this would work.
What if you have a low 10k or less mile cobra everything inside is still practically new, I dont see a gain there.
But if you have a 40k+ mile cobra and decide to do thismod you might gain your 5-10 hp back thats you lost. because of the oil/dirt build up.
This mod is just like cleaning your intercooler underneath the blower. It will performe better after you CLEAN IT, It will not perform better than a brand new one.
Just my 2 cents.
Stiegemeier said:Service finish is worth 1/2 of 1 percent. Cleaning blower and bearing assemblies with a garden hose is NOT recommended.
Stiegemeier said:Service finish is worth 1/2 of 1 percent. Cleaning blower and bearing assemblies with a garden hose is NOT recommended.
hey was wondering what numbers you were putting out with your set up? and if you thought that the trip to amazon was worth it ? i am looking for someone to tune my ride and am not happy with the local shops.JayplaySS said:YUP! I did the same thing when I installed my Ported Eaton. I polished the entire lower for 2 days, looked like a mirror. I am SURE it helps the velocity of the air comming out of the I/C. I also went a step beyond and lightlt ported the bend into the actual cylinder head for each cylinder. It was a rough as sandpaper before, but now its as smooth as a......polished surface. At 17+ lbs of boost, Im sure that air is much more efficient! I will be installing the KB 2.6 in a few weeks and I will post some pics then.
I am also going to cover the top of the engine valley with themowrap before I install the lower back on. Every little bit helps.