This. And what did you do for the idle air inlet?Does the blade fully open or does it hit the factory inlet divider?
You have to cut that out. Dremel worked good for that. Stuffed a rag behind it and had the shop vac sucking the dust while i was cutting.Does the blade fully open or does it hit the factory inlet divider?
Idle Air Control IAC Restrictor Plate Fit for Ford Mustang V8 V6 GT 4.6 5.0 3.8 1986 - 2004 https://a.co/d/5ffMT6fThis. And what did you do for the idle air inlet?
Idle Air Control IAC Restrictor Plate Fit for Ford Mustang V8 V6 GT 4.6 5.0 3.8 1986 - 2004 https://a.co/d/5ffMT6f
I have that tied into the pipe before the throttle body.This. And what did you do for the idle air inlet?
In the old bbk throttle body it was blocked off, there is no inlet in the Accufab throttle body.That's just a plate. Did you block off the inlet in the throttle body?
So far so good with mine, just bolted it up.FWIW, I had to tweak the throttle stop on mine a touch to get the idle solid and make sure it worked smooth.