600HP KB COBRA/MACH1 16K miles

centex

New Member
Established Member
Joined
Apr 19, 2011
Messages
29
Location
Waco, TX
600HP! 2003 Cobra/Mach1 16K miles

2003 Azure Blue mach 1 with 16k original miles and clear title. Never raced

The Engine was professionally Balanced, Built, and Installed by Ted Eaton (Eaton Balancing) and Jody Gunter (Gunter Specialty).

Engine:
NEW 2003/2004 Cobra Terminator Engine (from Ford)
-15cc Forged Diamond Brand Dished Pistons filed to fit ring set
Total Seal Piston Rings
Heads- Fully Ported with multi-angle valve job, bronze guides, Ferrea S.S. Valves, Crower Hi-Rev Spring and TI. Retainer kit. (Fox Lake Power Products)
ARP Head Studs
ARP 2000 Series Rod Bolts
Billet Cobra Oil Pump
Ford Motorsports Oil Cooler
Canton Road Racing 10qt. Oil Pan with Windage Trey
Evans Waterless Coolant System
AFCO Heat Exchanger
160deg. Thermostat
NEW A/C Accumulator Assembly
NEW A/C Compressor

Transmission and Drive Train:
NEW Cobra T-56, 6 Speed Transmission (from Ford)
Spec Stage 3+ Clutch and Pressure Plate
Spec Aluminum Lightweight Flywheel
Steeda Short Throw Shifter
Ford Racing 3.73 Gears

Supercharger and Intake:
Kenne Belle 2.2 Supercharger with 2 7/8" and 3 5/8" pulleys (14-20lbs boost)
Cold Air Intake
SCT BA 2400 Mass Air Flow Sensor
Steeda Supercharger tensioner

Fuel System:
Lethal Performance Complete fuel System with DUAL Fuel Pumps and Drive Modules with Wire Harness Kit (Supports over 1000hp!!)
FORE Precision High Flow Fuel Rail
Ford Racing 60lb Fuel Injectors

Exhaust:
Hooker Longtube Headers
Flowmaster 44 Series Cat-Back
Off-Road X-Pipe

Suspension and Brakes (all done by Performance Speed Tech-Motorsports Ranch)
Eibach Multi-Pro R2 Coilovers (Front & Rear)
Tubular K-Member
Tubular A-Arms
Lower Control Arms
Sub-Frame Connectors
HPM Caster Camber Plates
Bump-Steer Kit
Drilled and Slotted Brake Rotors
High Performance Road Racing Brake Pads

Wheels and Tires:
SVE Anthracite Cobra Wheels 17x9
TOYO RA1 Road Racing Radials 275/45/17
Original Mach 1 Wheels and Tires included with less than 5k miles 17X8 (Goodyear Eagle 245/40/17)

Tuner:
SCT Predator X-CAL 3 Super-Tuner
593HP Race Tune and 563 HP Street Tune
Tuned by Curtis Fullengen of Archangel Motorsports (Tulsa, Ok)

Extras:
Dual gauge pillar with PRO-COMP Boost and AIR-TO-FUEL gauges
Smoked Headlights and Fog Lights (can be switched)
Tinted Tail lights and Side Reflectors (can be removed)
5% Window Tint

(I have just recently added the tinted fog lights which are not in the pictures and xenon 5000k headlight and fog light bulbs, all of which can be switched with the factory lights if you choose so)

Asking $26,500
...I am in no hurry to sell, so please do not send me any low-ball offers. And if you can not afford or simply do not like my price, please do not respond. I am not interested in your opinion on my price, so please post for serious buyers only as this car was not build on a budget, so will not be sold on a budget. On the other hand, if you are seriously interested I will be more than happy to answer any questions

Pics available below:

http://s1133.photobucket.com/albums/...h/Blue Mach/
 

centex

New Member
Established Member
Joined
Apr 19, 2011
Messages
29
Location
Waco, TX
2003 Azure Blue mach 1 with 16k original miles and clear title. Never raced

The Engine was professionally Balanced, Built, and Installed by Ted Eaton (Eaton Balancing) and Jody Gunter (Gunter Specialty).

Engine:
NEW 2003/2004 Cobra Terminator Engine (from Ford)
-15cc Forged Diamond Brand Dished Pistons filed to fit ring set
Total Seal Piston Rings
Heads- Fully Ported with multi-angle valve job, bronze guides, Ferrea S.S. Valves, Crower Hi-Rev Spring and TI. Retainer kit. (Fox Lake Power Products)
ARP Head Studs
ARP 2000 Series Rod Bolts
Billet Cobra Oil Pump
Ford Motorsports Oil Cooler
Canton Road Racing 10qt. Oil Pan with Windage Trey
Evans Waterless Coolant System
AFCO Heat Exchanger
160deg. Thermostat
NEW A/C Accumulator Assembly
NEW A/C Compressor

Transmission and Drive Train:
NEW Cobra T-56, 6 Speed Transmission (from Ford)
Spec Stage 3+ Clutch and Pressure Plate
Spec Aluminum Lightweight Flywheel
Steeda Short Throw Shifter
Ford Racing 3.73 Gears

Supercharger and Intake:
Kenne Belle 2.2 Supercharger with 2 7/8" and 3 5/8" pulleys (14-20lbs boost)
Cold Air Intake
SCT BA 2400 Mass Air Flow Sensor
Steeda Supercharger tensioner

Fuel System:
Lethal Performance Complete fuel System with DUAL Fuel Pumps and Drive Modules with Wire Harness Kit (Supports over 1000hp!!)
FORE Precision High Flow Fuel Rail
Ford Racing 60lb Fuel Injectors

Exhaust:
Hooker Longtube Headers
Flowmaster 44 Series Cat-Back
Off-Road X-Pipe

Suspension and Brakes (all done by Performance Speed Tech-Motorsports Ranch)
Eibach Multi-Pro R2 Coilovers (Front & Rear)
Tubular K-Member
Tubular A-Arms
Lower Control Arms
Sub-Frame Connectors
HPM Caster Camber Plates
Bump-Steer Kit
Drilled and Slotted Brake Rotors
High Performance Road Racing Brake Pads

Wheels and Tires:
SVE Anthracite Cobra Wheels 17x9
TOYO RA1 Road Racing Radials 275/45/17
Original Mach 1 Wheels and Tires included with less than 5k miles 17X8 (Goodyear Eagle 245/40/17)

Tuner:
SCT Predator X-CAL 3 Super-Tuner
593HP Race Tune and 563 HP Street Tune
Tuned by Curtis Fullengen of Archangel Motorsports (Tulsa, Ok)

Extras:
Dual gauge pillar with PRO-COMP Boost and AIR-TO-FUEL gauges
Smoked Headlights and Fog Lights (can be switched)
Tinted Tail lights and Side Reflectors (can be removed)
5% Window Tint

(I have just recently added the tinted fog lights which are not in the pictures and xenon 5000k headlight and fog light bulbs, all of which can be switched with the factory lights if you choose so)

Asking $23,500
...I am in no hurry to sell, so please do not send me any low-ball offers. And if you can not afford or simply do not like my price, please do not respond. I am not interested in your opinion on my price, so please post for serious buyers only as this car was not build on a budget, so will not be sold on a budget. On the other hand, if you are seriously interested I will be more than happy to answer any questions

Pics available below:
Blue Mach pictures by cdieterich - Photobucket
 

blamb0912

New Member
Established Member
Joined
Jan 16, 2011
Messages
390
Location
chattanooga,tn
This is what I had wanted to do with my Mach but eh...FANTASTIC top notch build...and worth every penny to be different! free bump
 

Users who are viewing this thread



Top