mach 1

  1. Jake@Lethal

    Ford Performance Active Exhaust Upgrade Kit for 2018+ Mustang GT’s and Bullitt’s!! Check it out!!

    Hey all! Ford Performance just released their Active Exhaust Upgrade Kit for 2018+ Mustang GT’s and Bullitt’s! These are specifically made to fit any 2018 and Up Mustang GT’s and Bullitt’s with Active Exhaust already equipped from the factory.The kits not only come with the Mach 1 Mufflers...
  2. Jake@Lethal

    Ford Performance Active Exhaust Upgrade Kit for 2018+ Mustang GT’s and Bullitt’s!! Check it out!!

    Hey all! Ford Performance just released their Active Exhaust Upgrade Kit for 2018+ Mustang GT’s and Bullitt’s! These are specifically made to fit any 2018 and Up Mustang GT’s and Bullitt’s with Active Exhaust already equipped from the factory.The kits not only come with the Mach 1 Mufflers...
  3. Jake@Lethal

    Ford Performance Active Exhaust Upgrade Kit for 2018+ Mustang GT’s and Bullitt’s!! Check it out!!

    Hey all! Ford Performance just released their Active Exhaust Upgrade Kit for 2018+ Mustang GT’s and Bullitt’s! These are specifically made to fit any 2018 and Up Mustang GT’s and Bullitt’s with Active Exhaust already equipped from the factory.The kits not only come with the Mach 1 Mufflers...
  4. Jake@Lethal

    777 Performance ALL NEW Mach 1 Front Fascia Kit NOW AVAILABLE !!!

    777 Performance just dropped their Mach 1 Fascia for the 18'+ Mustang ! Get your's in the link below! https://bit.ly/3zxnR24
  5. Jake@Lethal

    777 Performance ALL NEW Mach 1 Front Fascia Kit NOW AVAILABLE !!!

    777 Performance just dropped their Mach 1 Fascia for the 18'+ Mustang ! Get your's in the link below! https://bit.ly/3zxnR24
  6. C

    WANTED: 03/04 Mach 1 5 speed

    Wanting to buy a clean title, 5 speed Mach 1. Budget is $10,000 Miles don’t matter too much as long as the car has a clean title, and we’ll cared for. Color also doesn’t matter, but would prefer no clear coat issues. Located in central Ohio, but willing to travel for the right car. Cash in...
  7. whipple04mach

    2004 Mach 1 low on torque?

    Finally finished my 04 Mach 1 project, got it dyno tuned and numbers were 555hp and 474 ftlbs. Does the torque seem low? What could be causing it? On everyone else’s builds, hp and torque are relatively close. Just a curiosity post as the car pulls just fine for what I use it for. 13# boost...
  8. slowgreycobra

    Machine Shop in Central Texas?

    As the subject line states, I am looking for a machine shop that I can trust to do the machine work for my engine. My 1969 Mustang Mach 1 has a 351C 2V currently residing in the engine bay with a toploader 4 speed behind it. I don't have it all set up to run yet, and I need to yank the engine to...
  9. ra03svtcobra

    2003 Ford Mustang Shop Repair Manual

    2003 Ford Mustang Shop Service Repair Manual Coupe Convertible GT Mach 1 Cobra 3.8L V6 4.6L V8 This is in like new condition. Complete with no missing pages. I used this once when swapping out the supercharger on my 2003 SVT Cobra. Sold the car so I no longer need this. Asking $130 and shipping...
  10. D

    2004 Ford Mustang Mach 1 Azure Blue

    Pains me but I'm listing my 2004 Ford Mustang Mach 1 Azure Blue I recently moved and had a new born, so I'm downsizing a little bit. I listed my 08' Viper and now this is next on the block. I've owned this car for 10 years but I'm really hoping to buy another bucket list snake 03-04 Cobra only...
  11. S

    WTB Clean Mach1 midwest

    Long time member but also hardcore lurker. Ready to step into a Mach 1. Mods, if I need to do anything special to be able to post this let me know how to comply. WTB a clean Mach 1. I am in Ky but would travel a couple hundred miles for the right car. I’ll list a couple of must haves. Please...
  12. C

    2004 Mach 1 For Sale in Central Ohio

    SOLD
  13. D

    WTB Mach 1/Cobra timing cover

    Hello, As the title states, I am looking for an 03-04 Mach 1 or 01 Cobra timing cover. Let me know what you have, thanks.
  14. K

    WTB 03-04 Mach 1

    Hi guy names Kevin I’m new to site so thanks for the add, im in the market for a new mustang would really like a blue mach 1 but will look at all Mach’s. Looking for lower mileage and manual, I would also entertain 96-02 cobras ! Thanks for looking
  15. H

    Changing out Printed Circuit Board in my 03 Mach 1 Gauge Cluster

    So several of the lights in my gauge cluster weren't lighting up. I pulled the gauge cluster and removed the printed circuit board. I found an area of corrosion on the board. I have ordered a used 2003 Mustang GT 5-speed cluster off of eBay. It uses the same exact circuit board. If I swap...
  16. D

    P0135

    Hello everyone, I am getting code P0135 (Bank 1 sensor 1 heater circuit malfunction) on my Mach 1. I have Mac longtubes, off road x pipe, and dumped spintech mufflers. I also have new NTK O2 sensors upstream. I have a bama tune. I have told them about the code, and they increased delay for bank...
  17. DanteDalaunte

    Exhaust hanging way to low

    So I got coil overs and put them to the lowest setting which I know that’s too low and I will raise them. (My headers and x pipe we’re constantly scraping on the road today, won’t be driving until I can get it on a lift.) But even before I lowered her the exhaust just was always so low. It’s BBK...
  18. C

    WTB 03/04 Mach 1, especially 04 CO Mach

    In the market for a manual 03/04 Mach 1. Car must have a clean title (no R title or Lemon Law cars). Mainly looking for Competition Orange Mach 1's but will consider all other colors for the right car. Looking to spend up to $14,000 max. Located in Ohio and willing to travel for the right car.
  19. Sketchy_Mach1

    What to do?? Mach 1 Build

    I recently purchased an 03 Mach 1 with 155k on the clock, and yes it is an auto car.. oh well. So far I'm loving the car, but like with anything the new is starting to wear off and I'm getting the itch to modify. Currently I'm looking at minor "bolt on" mods, but eventually I would like to plan...
  20. bluedgemach

    From the Carolinas

    Just sold my Black 2016 PP Mustang GT Premium for an Azure Blue Mach 1 from a member on here that dates back a few years ago. Haven't really ever been active on here besides searching the For sale section. So not new, but kind of. But without further a-due here's the new ride...
  21. D

    Need New fuel pump

    I need a new pump for my 2004 Mach 1, car is pretty much stock. I may mod it a little here and there in the future but probably nothing big. Maybe, a cold air kit, gears, and a tune. So any recommendations on what pump to get? Should I go OEM? or something like a Walbro 255 LPH?
  22. Christianmiller456

    Looking at buying Matthayn's old Mach 1 aluminator...

    Like the title says, Im brand new here and I have ran across the Mach 1 that was built by Matthayn with the aluminator and ported eaton e85 set up a couple years ago. I found it on craigslist and all the photos there can be found here as well. Im setting up a test drive for this weekend. Ill let...
  23. Chris_Blown4V

    !!! 2003 Mustang Mach 1 !!!! 12K

    Hey guys!! Here I have my 2003 Mustang Mach 1 in very clean and great condition. Car has been kept up with and maintained with oil changes every 2,500 miles. Car has a CLEAN TEXAS TITLE and has No Liens or payments owed on it. Car has never been in a wreck or damages. It currently has 110,xxx...
  24. C

    Cooling problems while open tracking 03 Mach 1

    To make a long story short, I am having cooling issues with a 2003 Mach 1 when open tracking it. It has a Vortech V3 supercharger with an air-to-air intercooler making about 450 whp. I don't have any cooling problems on the street or at the drag strip. I only have problems when I'm pushing it...
  25. RyanAa43

    04 Yellow Mach w/ 70k miles + supercharger in Chicago

    Trying to sell my 04 Mach 1 w/70k $9500 5 speed manual Located in Oak Forest IL, 30 mins south of Chicago (nice neighborhood, not the "south side" you're thinking of for you out of staters who might wanna come check it out) 70k miles with some upgrades, more info and pics in the CL ad at the...

Top