Stock gears, just opened it up to swap axles.
So this mount you speak of.....I just unbolted the part that bolts to the floor and the part that bolts on the ear at the top of the rear end, and replaced with the UPR upper. I used the factory bolts. Should I have done something different...
So I made a bunch of changes in the back of the car, got it together and I'm not sure I can live with the gear whine from 50-65mph, its extremely loud! Here's the list of changes I made:
BMR UTC019 Upper
TCA018 Lowers w/ relo brackets
QA1 DA Shocks
Moser 31spline c-clip axles
Royal...
While I had the car in the air for the BMR rear suspension install I decided to do an axle swap as well. I unhooked the e-brake cable out of the caliper clip like shown without much effort. My issue is upon reinstalling both sides is I found the passenger side would be essentially engaging the...
I got some id1300's and started fitting them into the car. The problem is the electrical connector is so close to the bottom of the injector it seems like it hits the intake before it's fully seated on the driver's side. On the passenger side it's even worse as the connector hits the heads.
I...
I can't imagine it would be a problem. I'm currently running 2 465lph pumps on E85 in a return system. They're in a dual hat so upgrading to triple pumps isn't as easy as just running a BAP, not to mention the other cons of 3 pumps.
1000-1050whp is the goal.
Looking to go to an 18" wheel to get a decent tire on the back, and can't see anything but the gloss grey F-14's going back on it. Hopefully someone around St. Paul/Minneapolis MN will be willing to meet as adding shipping to the deal just won't make sense for either party I don't think. Price...
These are plasti-dipped black. They were new take-offs when I coated them, and I put about 1200 miles on them before I pulled them off for Magnaflow's.
Looking for $425 shipped.
Thanks!
These are plasti-dipped black. They were new take-offs when I coated them, and I put about 1200 miles on them before I pulled them off for Magnaflow's.
Looking for $425 shipped.
Thanks!
I'm going to a GT500 front so I'm selling the following with about 4,000 miles on them:
--Roush front splitter-SOLD
--Ford GT/CS driving lights. Perfect shape, I did cut the bottom opening to get away from as much of the plastic look as possible, turned out great. $160 shipped.
--Roush lower...