Hi there, I have a 1990 Mustang 5.0 with Vortech V1. I had a head gasket leak so I replaced the head gaskets with new intake gaskets and ARP head studs.
I torqued my rockers down to 25 ft lb.
I torqued my lower and upper intakes.
I pulled the #1 spark plug out, placed my finger over it. Right...
Hey guys my 04 cobra runs and drives good until I do a few wot pulls.
my transmission gets harder to put in any gear. If I park the car and come back to it, it gets better.
It has 32k miles I’ve changed the trans fluid and I’ve added a MGW Short throw. What could be the concern?
I have 2004 Cobra with the stock eaton supercharger & stock pulley. Only has a JLT CAI, Catch Can and a PreFilter and the Cylinder Head Cooling Mod, Stock Manifolds with Off Road X Pipe and Borla Stingers.
I’m looking to purchase a 2.3 Whipple Supercharger. I was wondering which Gen would be...
so I’ve wired my FireWire. It changes at around 2.76V at idle. On analog 8 I wrote my equation on LiveLink and hit the green arrow. Does that mean my equation is set? Also it still reads in volts on my SCTX4 Is that okay?
I have a AutoMeter Phantom wideband 5779 installed. I got my SCT fire wire and need to wire it to the wideband. Is there a diagram for the auto meter wideband? Thanks
I don’t have to hold the gas. I have to tap at it.
Codes
32 - EGR Valve Position/Pressure Feedback EGR Voltage Below Closed Voltage. 0.24 volts (O,CM,R)
67 - Park Neutral Position Switch Circuit Open; A/C On -Manual (O), Manual Lever Position Sensor Out Of Range/A/C On (CM,O), Clutch Switch...
I just finished rebuilding my 302 for my 1990 mustang 5.0. It is bored 0.30 over. I fired her up, bleed the cooling system & set the timing to 10 degrees. My concern is once the car warms up it doesn’t like to start. It has good fuel rail pressure, new injectors, pump, and fuel filter. I feel...
Okay so I followed the video for MMR. I installed the timing chains. I rotated it two revolutions and the markings are back to the same spot as how I started. I’ve supplied pictures. Cams look neutral. Is this correct?
Yes I did watch em. My issue is I didn’t watch the videos before so I didn’t follow the removal procedure. Now the chains have to go on and the cams aren’t in correct positions.