Recent content by silver93

ill buy the fronts

any trades?

damn that is the same truck i have a 2003 cc 4x4 7.3 lariat i was gonna offer you.

sweet ass truck for sure. would love to have it

what kind of diesel you looking for?

It is the sending unit. Installed mechanical gauge and oil pressure was all good

I got a foxbody swap with a term engine notice today at the red light the dash was showing no oil pressure. Bump the throttle and jumps back up. Driving it all reads correct. When idle and showing no oil pressure on the dash. There is no rattle or engine noise. Could it just be the sending unit...

yeah its hot and humid here in louisiana. i haven't seen 230 so if thats the case i should be fine

I'm starting to believe that is a lot of the problem. i have burped it a few times today. the crazy thing is i mounted the sensor for the mechanical auto meter temp gauge on the driverside of the block near the rear freeze plug. the gauge is reading around 210 but the fan cycles off and on but...

I'm going to burp the system again in the morning. but i was thinking the same thing that it should be running cooler when driving. excpecially when its about 85 degrees outside in the evening

the radiator i bought is a mishimoto 2 core radiator for the 99-04 cars it is bigger than the radiator i took out the car for sure. as far as the fan i can't say its factory stock but it plugs into the factory harness on the car. i might try to mount it in the bunge were you burp it at. you...

ok guys i bought a fox body coupe with a 03 cobra motor in it. car i stock beside upper pully and intake. i got the car home and made a pull on it then went to the store to grab a drink. in the store i notice it was pushing water out the degas as if it was running hot. i ran killed the car and...

Thanks guys

Best place to install mechanical water temp gauge on my engine. Should I remove the factory temp sensor and install there or is there a better spot for more accurate reading.

thanks