Recent content by PotatoC570

I was not planning to run too much boost through. That is why I saved the money and went with cast because I am not looking to go and get 600hp out of it. I have fun with it being N/A. I gaped the rings just a hair bigger for boost in the future. But, I would be happy with high 400hp maybe lower...

I have a 99 with a fresh rebuilt. I have 03 heads installed. Forged Crank, Forged Rods, and Cast Aluminium pistons in. The pistons are slightly dished nothing crazy, but I have a full 03 terminator gasket kit in. I snapped a timing chain and either I got lucky or I have enough clearance that...

Yes. I was just cruising down the highway in 5th gear doing about 60, then there was a slight incline and I lost all power. No knocks, not clinks or clanks. Had oil pressure. Not even a code until I shut it down and restarted it. I don't know if the chain itself failed, or if there is a cam...

I put on brand new heads, new forged crank, forged rods, and a set of dished cast pistons on. HO oil pump. The only thing that was not brand new was the timing set which was replaced when I purchased the car. I put 20k miles on the car before I the rod bearing spun and snapped my rod.

I rebuilt the motor and timed it myself the first time. I will do it again.

I do have dished pistons in the motor because I built it for boost. Also I have a terminator gasket kit in which is a touch thicker than the standard cobra. Can I pull the pan in the car?

Good Morning fellas. The past few weeks have been hectic for me but I finally got some time to work on my car. I had an issue where code P0340 would show up and my car was only running on half the motor. After wire chasing for days, I decided to pop open the valve cover on the driver side...

The alternator thing did not work, it still acts up. Still have the cam code, how do I check the FRPS.

So how do I check the FRPS when I go home? Also, I posted those links for you to read.

http://www.allfordmustangs.com/forums/4-6l-tech/309132-p0340-error-code.html https://www.stangnet.com/mustang-forums/threads/p0340-camshaft-position-sensor-circuit-fault.721665/...

No, I did not. But, why would the FRPS throw code P0304? Would it not throw its own code? The only engine code I have is because of the cam sensor issue. If I take it off how do I test it?

I am having issues with my 99 cobra. About a week ago I lost all power to the engine and had to get towed. I have 400 miles on my rebuild after getting the kinks worked out of it. Now I was able to get a reader from my friend and I threw code P0340 which is a cam position sensor code. I...

I put pulled one spark plug at a time, plugged it into the coil pack and rested it on the engine, as I cranked my step dad watched and saw that all 8 had spark.

It is really hard to tell which one are firing and which are not even if that is the case. When I pulled the plug and turned it over it started up every single time. I went through all 8 and they all had spark and you can hear the pistons "popping" with the air pushing out. If it was a timing...

I went home last night and checked. I have spark going to all the plugs, I also smell raw fuel dumping in. So that would leave air, is there a possibility that the MAF or TPS just quit?