Recent content by nikkodnp

The engine has a cobra intake, stock heads, stock cam, stock bottom end. I havnt done a compression test on it, but there is no noticable smoke coming out the back other than a puff when shifting at high rpm’s. It sounds like it may be worth a try with a 3/8 NPT/ Hose fitting, tapped into a...

I havnt tried another PCV valve, which would you recommend? I think the PCV valve would be closed at WOT, so with the crankcase pressure at its highest it needs to be relieved through the valve cover vent(s). One vent may not be enough, thats my reason for adding a secondary vent on the...

Thanks for the input. I live in CA where i know a breather wont pass the visual. I want to know if there will be any issues in running dual vents to the throttle body in my fuel injected setup. Im looking at drilling and tapping a 3/8 in NPT barb on the driver side valve cover.

Hi everyone, Car is a 89 5.0 LX with a T5 and 168,000 miles. There is a Steeda firewall catch can installed from the rear PCV then back to the upper intake on the rear. Ive been searching the internet for days now and have yet to find anyone who has tried or questioned this. Basically i...

Here is the direct website to the yard! EncoreMPW The Mustang Parts Warehouse

Sorry to hear that Mustang5L5! I actually stumbled on this video on youtube recently and it looks like theres a lot of good candidates. 2019 Ford Mustang Salvage Yard Tour Restoration Parts OVER 100 Fox Body Donor Cars & Rolling Chassis Luckily, my defroster lines are still working, although...

Hi SVTP Forum! I recently tried to realign my hatchback to body at the hinges because there was such a large gap that was allowing air to come in from outside along the weatherstripping. Long story short, im wondering if there was a source for foxbody rear hatch glass with defroster lines...

i've heard that as long as there is a 30mm offset then you can put up to 255's with no issues. Is this true?

Pics? Saw this and thought it looked pretty dope

I've been looking at 1999 cobra rims for the fox, apparently it already comes with 30mm offset, so thats awesome. Did a quick mock up and this is what it could look like Now i just need to find a set i can buy in good condition

What rims are you using for this?

I might just go with the 03 04 cobra rims as a tribute to the IRS setup underneath, but we'll see. Would you say it's worth the work and have you noticed any major benefits since then ?

I'm currently deciding on whether an 04 cobra IRS will be able to fit 17x9, 24mm offset and 5.94in backspacing into a foxbody mustang. The rim has Nitto 275's https://lmr.com/item/WTK-1007NZAK/Mustang-Pony-Wheel-Tire-Kit-5-Lug-17x8-9-Silver-Nitto-NT555 I have heard that some people mill down...

I've been looking at the 5 lug pony's to work with the IRS setup, Will the 17x9 24mm offset and 5.94 backspacing and 275/40 work as is with the irs fox as a direct bolt on? https://lmr.com/item/WTK-1007NZAK/Mustang-Pony-Wheel-Tire-Kit-5-Lug-17x8-9-Silver-Nitto-NT555 I'm thinking about getting...

Just had the controller and fan in my car for a good few months now So far it's working great in terms of cooling my fox. I have a 195* thermostat and set the controller to turn on at around that temperature. According to the dash guage (however accurate its is) it usually goes up to the 2 1/2...