Recent content by mf150

Hey there, when making turns and accelerating at higher rpm, I lose oil pressure according to the gauge. This pressure loss lasts till I straighten out, then the needle goes up again. I have not seen a raise in water temp, nor have I had any problems with power/new noise...etc. any...

Have any of you had (or heard of someone who has had) problems in San Mateo County with the police around legal modifications? It is my understanding that to curb street-racers, the whole county is targeting loud, flashy, and otherwise unusual cars to pull over and randomly inspect. If it...

Just wanted to drop a line and say thanks to Billy for doing such a good job on my clutch, today. I'll be buying the new OEM clutch cable, along with all the other stuff. In fact, he did such a good job, I will be back next month for head and cam work...also a header install...

Been researching TOBs for teh past few weeks in anticipation of my upcomming MSX clutch and flywheel install. I have concluded that the Ford OEM (Valeo) and the FRPP HD (Valeo) are exactly the same. Due to their problematic noise-making tendancies, I have been branching out in a search to...

just as teh question states? I have heard that this is true.

any advice or experiences. There is quite a price difference (FRPP-$30) and the (Valeo- $10). They look exactly the same! anyone care to enlighten us as to what the difference is??? Thanks

Anyone have any contact info. or an update as to what he is up to...I spoke with him a few months ago regarding a clutch install...tried to get him recently, and no response... anyone know what's up?

FRPP 4.30s with fewer than 10,000 miles on em. make me an offer.

Hi, Have a school buddy who was arrested last night and cited for VC23109, Speed Contest. From what I heard, he was trailing two other college buddies down a three laned 35 MPH zone, the other two buddies took off under an overpass (obviously to hear the exhaust systems on their cars, and...

Hi, I was thinking about getting turn downs before the axle on my 2003 GT. I am having fitment issues with my Borla Stinger Exhuast, and the tail pipe is rubbing against my axle tube (which may cause a hole in the future). Are Turn Downs Illegal?

Had my 8.8" built up again (second time). I took it to Ford the first time for the install. This time, I took one of the Ford tech's advice. I went to Bayshore Truck Equipment Co. in South San Francisco. Adolfo is the most thorough machinist that I have seen ( a true master)...he measured and...

will be for sale to local buyer...lowers your stang 1.2"/1.0". been on car for fewer than 7000 miles. Install possible. PM for questions. asking price $100 shipped

Lightning Larry, who do you recommend, sir? thinking about going comp cams w/ comp cam springs. WERD!

99+ axle bearing inner and out diameter needed for a ford 8.8" rear.

What fluid do you use? and what weight?