Recent content by Flores8787

Alright guys I was able to fix the surging RPM, it did resulted to be a torn hose connector that connects to the S/C. RMP is normal now , check engine is gone and power is back. however now the Cobra is dying every time I hit a stop, this did not happen before. I have cleaned the MAF sensor a...

hey guys so I had these codes pop up a couple of days ago, did some troubleshooting and finally found the source ; I have a line that is torn right at the elbow just behind the S/C. its the one that looks kind of thicker than the other. ill try to post a picture. any ideas of a part # or how...

Thanks for the replays guys Here is a video of the noise

So the following issue started a couple of days ago after a week I had a new clutch kit and flywheel installed. There is a noise very mild , kinda like a "rattle " that only comes up when I floor it on 5th gear , I can't seem to hear it on 2nd , 3rd or even 4th gear. Any ideas guys? I'll...

very smart , but I actually like the new pedal height , just not the pedal play it has now.

hey guys! so about a week ago my TOB gave out, took cobra to a shop and had the tranny brought down for the labor. after carefully inspecting this is what went down -had a new clutch kit put in since tranny was down , exact same one it had on with new TOB . - New aluminum flywheel was put on...

So guys another day another thing with the Cobra. The car is having a popping in the steering when I turn it at low speeds or parked. Front end feels lose in the high way when I hit a bump or something. What do you guys think? Inner, outter tie rods? Rack and pinion bushings ? There's no leak...

ok guys, I finally got some mods for the cobra, I went for the 2.93 billetflow sc pulley and the 100mm*aux idler and 90mm metco idler pulleys and will get a tune. now searching what belt size I require for this set up? looking for gates belt . thanks guys!

Tried everywhere to find a gatorback belt , but will go with gates for now. Probably a dumb question. What is the size belt i need for stock idler pullies.? Stock upper. All stock. Looking for the green belt. Part # ? Thanks guys

it's seems like its time for a new belt. I have a bad chirping under the hood. I have been looking for gatorbackbelts for stock pulley set up. By no luck so far. What are other good belts out there!? Or where can I still buy gatorbacks ? Thanks

So guys I replaced the stock stereo unit on my 03 cobra vert in order to have Bluetooth! Used the metra 70-5519, I've connected all wires and gone over and over them, but some how I can't the rear bottom speakers to work! ( verts have two rear upper and two lower speakers) has anyone gone...

so after owning my first cobra for two months now, ive had to replace the Cooling fan and currently working on 02 sensor malfunction. cobra is currently stock and I was considering some upgrades. I basically have a budget of $1000 right now. I was thinking about JLT RAI, Upper and lower pulley...

Hello guys ! So my engine light came on today :fm:I am getting a code P0155 bank 2 sensor 1. Heater circuit malfunction. 03 cobra is stock, no upgrades on mid pipe or cat back yet! Has any one gone through this before? How can I solve this? Is this referring to the 02 sensor on driver side? Any...

new to this forum guys! I just bought my 1st 03 cobra today convertible . bone stock, it even has the pulley cover on it :-D its grey with black top, it has 48000 miles on it. So I am ready to start modifying this cobra. what are some suggestions on where to start? and again this cobra is...