Recent content by clinton2003

Sai li makes a very budget fuel system. Lethal performance and jpc make a budget fuel system. Or fore innovations makes a real fuel system.

for gen 1 intake vs the boss. The gen1 beats it all over the low end up to about 6800rpm or so. then thats where the boss intake makes the power... So if your not going to be tracking the car, Stick with your stock intake, or get a gen3 intake. porting may gain you some, but not enough to...

have you tried loading the stock tune back in? tested to see if it still does it?

Could be a tune issue.

Recon mostly hit it, but figured i'd put in my $0.02 The RS3 (Roush Stage 3) is a Stock GT with body kit (Stage 1), suspension upgrades (Stage 2), and a blower installed (Stage 3). Unless it was custom done by Roush it wont have any other upgrades. Safety upgrades include but not limited to...

If you have the willpower to keep it lo . Then great. Most of the people i know we lie to ourselves. 800 will be enough, then 1000, then 1200, then...... I have a probelm, i told myself that i just wanted to run an 8, now i just wanna run a 7.... hopefully i will be satisfied, but you never...

IF the headers come with the x pipe, AND is meant for a 3" catback, then you should be good. If its meant to hook up to factory (2.75") then you may have an issue with the magnaflow catback... as it looks to be a full 3" setup. I'd assume you could call ARH and see if they know if it will...

there are advantages/disadvantages between the aluminator, gen2 shortblock, and a built shortblock. aluminator has manley h-beams, and forged pistons. but ring gaps that are too tight for higher hp applications. (at least the 11:1 comp one does) gen2 has powder forged rods (strong, but not as...

shouldnt NEED the dust shelds, or the brake lines.

weight savings of course! crazy thing is when people go to a fiberglass hood, usually its a HEAVIER hood... lolol

how would different bolts for water pump change what balancer you run... especially when you can swap the pumps on the car interchangeably (as long as you change both water pump and water pump pulley for the correct bolt pattern obviously)

My gen1 with opg's held up many hard miles at >800whp We are talking about 15k+

I would agree. You match timing components and cams to gen of the pcm. The od balancer would allow you to run a bigger blower pulley reducing chances of slip. I thought the ati balancer was for 11-17, possibly all coyotes?

Doubt they have sodium filled valves, and possibly have boss springs. But i dont trust the boss spring . They wear out relatively quickly. I currently run the trick flow (pac) springs with 209lbs pressure, cant remember part number. Most use the 1234x springs which have more seat pressure, like...

If you have gen 2 heads then your mostly there. If your going to push it at all grab valve springs (like 400), and aftermarket secondary chains (roughly double price of stock's and worth peace if mind). Ya ati balancer will balance out any other harmonics and keep engine smooth. Easier to oull...