I have one from a JLT RAI Gen2 that looks brand new. Just bought a kit and I won't use the sheild (why I would hide these Scott rods panels? :P)
Might not be cheap to ship from Canada to the US, but would sold it to you for 20$ + shipping. If you give me a postal code I could check for a...
The Falkens will be narrower and honestly go with the R888. I have the 615k in 315 and they barely hook more then my hold BFG KDW 295. I originally wanted the R888 but they were BO at the time.
Hi guys, I would like to know what is to replace after a front impact where the 2 air-bags were set off. I assume that the 2 bags and module needs to be replace, but what about seat belts (that are already junk and almost not retracting even before the crash) and maybe any reflash of the ECU...
So I finally decided to pull out old Tstat and install my Reisch 170. Is anybody able to tell me if the one on the right in the Google Drive link below is the OEM? It is marked "54mm", "USA" on top and "X", "STC" on the bottom. The new one is marked "56mm", "USA" on top and only "STC" on bottom...
Hi guys, a friend of mine is looking to buy an 03 cobra and we would like to have advices from knowledgable people. The car a 73000miles US "totaled" title but repaired (very common here). It has upper, exhaust (x + cat-back) drop springs, few gauges, sub-frame connectors, center-force clutch. A...
Hey guys!
Do 80lbs injectors are too big for a pullied/ported eaton with full bolt-ons? What would be the cons to use such a big injector? I know that the best would be 60s, but just found a new set of 80s for very cheap.
Thanks!
Yesterday I was going at a big local ford show, car ran great during the trip, but when I stopped to enter the show I was hearing the pumps going ON/OFF pretty loud, louder then normal. Normally I can hear them while the car is not running that is fine.
2003 cobra
Stock pumps
KB BAP installed...
My car has a good drop so it's logic to have shorter end-link, but also i'm having interference problem between the coil-over and the bigger eibach sway-bar, impossible to drop further.
It is a simply 2 studs on the same side, anyone tried to find another length end-link from another car model...
So here is my problem, just got my wheel and tires which are 18x9.5 ET30 with 275/40/18 and the tire is slightly rubbing the bottom part of the spring. If I remember correctly I have Hypercoil 12inch springs. I'm also running MM camber/caster plate ans I was able to have a bit more room by...
Hi Guys, I will be replacing my sway-bars with the eibachs. In the rear, does the gas tank need to be dropped or it's possible to replace it with the tank in place and the IRS fully assembled? The car is currently on jack stand with only the wheels removed.
Thanks.