I just had my brakes redone, and didn't break them in good, and they are glazed. The noise is pissing me off. Is there any way to fix this without having them turned again or buying new rotors? I was told a 90 degree sander and an abrassive might work, but you want to keep the thickness of the rotor the same around the whole think because if not you'll start getting into shimming, and all that mess when you go to braking.
Would a 90 degree sander and a brillow pad disc remove the glazed area?
Thanks,
Jesse
Would a 90 degree sander and a brillow pad disc remove the glazed area?
Thanks,
Jesse