A little over a month ago I had installed a set for Ford Racing K-Springs and a Hotchkis Rear suspension package by a local speed shop and my car had been returned to me with a loud clunking noise. My car was returned to me and I was very displeased with this as I told the shop that it was no longer nessecary for them to try and resolve the issue and that I would take care of it. I called Hotchkis and they had appeared to be quite puzzled as to the issue so I took to the forum. The popular answer was that the UCA mount needed be replaced. I contacted Kelly at BMR and they agreed. So then I had ordered the mount and began tearing everything apart. Mind you I am 23 and nowhere near mechanically inclined, this was a NIGHTMARE. Once everything was off I reinstalled. the mount to the UCA and began reassembly. Once I got to installing the mount to the frame the frame holes on the car did not line up with the mount holes. Puzzled for 2 weeks every day I tried to figure out the resolution. Finally I dissasembled the mount and the UCA and concluded that I had over-torqued the bolt holding the UCA in the mount causing the mount holes to be off. Once I figured this out everything went back in together within 20 minutes. I called Kelly every day attempting to figure this out and he was more than accommodating and helpful in figuring this out. If you are to install an aftermarket UCA, MAKE SURE you buy an aftermarket mount because the slop in the stock mount is as shown.
After the customer experience I have received from Kelly I can tell you all that I will be back to purchase more components from these guys, everything fit when installed properly and customer service was outstanding. Thanks again!
Before the drop
After.
After the customer experience I have received from Kelly I can tell you all that I will be back to purchase more components from these guys, everything fit when installed properly and customer service was outstanding. Thanks again!
Before the drop
After.