Where can I find a stock pulley kit?

[3ric3288]

Seriously, everywhere I look its all underdrive pulleys and I already have a steeda but I hate it. My voltage output at idle is ridiculously low, about a quarter above the line which in turn flickers my HID's. I have a high amp alternator already. I would like to replace it with the stock pulley kit that is new rather than used unless I can find a good used one. I would be more than happy to keep the pulley kit on if:
A. A different gear ratio (4.10) will fix it due to higher rpm's
B. Somebody has a solution to this

Any help would be appreciated, thanks.

 

[makriluc]

Just post in the Market section.
That's what I did a month ago after finding out I had under drive pulleys, and I could'nt fit my new Procharger install. They were used but the original owner cleaned them so good, they looked new.

 

[na svt]

I have a stock damper and water pump pulley that i can send you. Wanna trade?
You'll have to go to Ford for a new damper.

Small diameter dampers and underdrive pulleys and are not nearly as bad as what some say. I've had them on every mod motor I've owned and have never had an issue with them. The only problem was an increase in hp.

4.10 gears are not going to change the alt output at idle.

What's the diameter of your alternator pulley?

 

[Noreast]

Worked fine on mine with stock alt

 

[3ric3288]

I also forgot to mention I have a sub system.

 

[na svt]

I also forgot to mention I have a sub system.

Have you checked the voltage at idle with all the power drawing accessories turned on?